New York Codes, Rules and Regulations
Title 9 - EXECUTIVE DEPARTMENT
Subtitle I - Office of Parks, Recreation and Historic Preservation
Chapter V - Marine And Recreational Vehicles
Subchapter A - Motorboats
Part 449 - Equipment To Be Carried On Public Vessels
Section 449.1 - Definitions

Universal Citation: 9 NY Comp Codes Rules and Regs ยง 449.1

Current through Register Vol. 46, No. 39, September 25, 2024

The following terms when used in this Part, unless otherwise expressly stated, shall be deemed to mean and include:

(a) Portable fire extinguishers; classification.

(1) A class B-1 extinguisher shall mean the foam type with a minimum charge of one and one-fourth gallons, the dry chemical type with a minimum charge of two pounds or the carbon dioxide type with a minimum charge of four pounds.

(2) A class B-2 extinguisher shall mean the foam type with a minimum charge of two and one-half gallons, the dry chemical type with a minimum charge of 10 pounds or the carbon dioxide type with a minimum charge of 15 pounds.

(b) Fixed fire extinguishing systems. Fixed fire extinguishing systems, hereinafter referred to as "fixed systems", shall mean total flooding systems using carbon dioxide gas as the extinguishing agent and having components fixed in position. The operation of the fixed system may be either manual, automatic or a combination of manual and automatic and must be approved by the United States Coast Guard for marine use. Each system shall be of such capacity to provide one pound of CO 2 gas for each 14 cubic feet of protected area. The inspector shall specify the size of the fixed system re-required [sic], the location of cylinders and components and the type of control. Fixed systems shall be required equipment on inboard motor boats and on outboard motor boats which have installed tanks and enclosed spaces, when such boats are used for carrying passengers. In cases where the construction of a vessel or the location of engines and tanks are mainly exposed to the open atmosphere, thus making the installation of a fixed system impractical, the inspector may omit the fixed system requirement and add to the portable extinguisher requirement, if deemed necessary.

(c) Ventilation. Ventilation shall mean the induction of a directed current of air by natural or mechanical means as opposed to venting which only provides openings for escape without provision for induction. Induction as used above means the intake of air from the outside which shall be directed to and through the length of the compartment and then released outside again. Any compartment or space in which an engine or fuel tank is located, particularly the lower portion of bilges, shall be provided with ventilation capable of preventing and effectively removing any accumulation of flammable or explosive vapor.

(1) Natural ventilation shall mean ventilation induced by the installation of permanently open and unobstructed inlet and outlet ventilation ducts, extending to bilges, with two ducts serving as inlets leading to the wings at one end of the engine compartment and/or fuel tank space and two ducts serving as outlets from the wings at the opposite end. The aggregate inlet area and the aggregate outlet area should be proportioned approximately to the beam of the boat, with two square inches of aggregate inlet or outlet duct area per foot of beam as the minimum. Where engines and/or fuel tanks are not in closed compartments, at least one ventilating duct shall be installed in the fore part of the boat and one in the after part. In the case of completely open boat construction using outboard motors and portable fuel tanks, no ventilation ducts are required.

(2) Mechanical ventilation shall mean ventilation induced by the installation of a power exhaust blower, in addition to the minimum requirement for natural ventilation, the motor of which shall be completely enclosed and sparkproof and shall be installed outside of ducts and as high above the bilge as possible. The exhaust blower shall be of such size as to exhaust the total air capacity of the compartment in a period of one minute.

(d) Life preservers. All life preservers used on public vessels shall be of jacket design, containing pads of buoyant materials consisting of balsa wood, cork, vinyl covered kapok, or vinyl covered fiberous glass inserted in a cloth covering which shall be fitted with straps or ties so that the life preserver can be securely held to the human body. All life preservers manufactured after 1949 shall be India orange in color, except that white colored life preservers which have been in continuous use are approved only if in good condition. Re-covering of life preservers is not permitted. In addition, all life preservers used on public vessels shall be of the commercial type approved by the United States Coast Guard for use on vessels carrying passengers for hire. Limited United States Coast Guard standards for life vests, buoyant cushions, etc. are not approved.

(e) Inboard motor boats. For the purposes of this Part, inboard motor boats shall mean all vessels with permanently installed engines and/or fuel tanks using gasoline or diesel oil as a fuel supply, or vessels having enclosed bilge, engine and/or fuel tank spaces using gasoline or diesel oil as a fuel supply.

Disclaimer: These regulations may not be the most recent version. New York may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.