New York Codes, Rules and Regulations
Title 16 - DEPARTMENT OF PUBLIC SERVICE
Appendices
Appendix 7-F
Current through Register Vol. 46, No. 12, March 20, 2024
FORM A
STATE OF NEW YORK
PUBLIC SERVICE COMMISSION
* * *
REPORT OF SPECIFICATIONS OF PROPOSED CONSTRUCTION
of
LIQUID PETROLEUM PIPELINE TO DE SUBJECTED TO PRESSURE
16 NYCRR 258.4 (a)
(Submitted in Triplicate)
* * *
Corporation ____________Date ________
Route: From ____________To ____________
New Construction ____________Reconstruction ____________
Counties traversed ____________
Towns traversed ____________
Cities traversed ____________
Incorporated villages traversed ____________
Estimated date: Start of construction ____________
Completion of construction ____________
Identity of line (corporation name or number) ____________
* * *
Required filing: The following maps, sketches, and drawings shall be filed with and as a part of this report:
(a) Three sets of current U. S. Geological Survey Maps (71/2 or 15-minute) sufficient to show the entire route of the proposed construction or reconstruction and an area of one mile on either side of the route. The route of the construction or reconstruction shall be clearly indicated thereon.
(b) Three sets of strip maps and design drawings showing details of the proposed construction or reconstruction.
* * *
Note: Where more than one construction type design factor is used, the specifications relative to each shall be separately listed. Where necessary, supply the requested information on attached sheets identified by the Roman numeral, number, and letter designation of the item on this form.
* * *
Length
Nominal outside diameter, "D," inches
Nominal wall thickness, "t," inches
Type and/or grade of pipe
Manufacturer of steel
Manufacturer of pipe
Type of longitudinal joint
Specified minimum yield strength, psig
Nominal ultimate strength, psig
Is pipe new or used
If used pipe is employed, describe the inspection and reconditioning
Mill test pressure, psig
Certified maximum operating pressure, psig
Calculated pipe stress (hoop stress) psig
Where PD = stress
2t
Ratio of pipe stress to yield strength, percent
Check of pipe specifications:
Are the physical and chemical specifications of pipe to be verified by outside laboratories?
By whom?
By whom?
What inspection procedures will be followed for detection of gouges, grooves, and dents for:
Factory coated pipe
Field coated pipe
Railroad crossings
List, giving location
Indicate whether cased or not; if not cased, provide basis
Road crossings
List, giving location
Indicate whether cased or not
Indicate if heavier wall carrier pipe is used
Lake, river, stream, or creek crossings
List, giving location
Describe any special construction precautions to be followed
Pipeline encroachments
List any encroachments to railroads, by location
List any encroachments to roads, in which special construction precautions will be employed; identify by location
Manual valves
Number of sectionalizing valves
Spacing of sectionalizing valves
Type, make, and location of any automatic valves to be used
If minimum prescribed cover and clearance cannot be maintained, indicate location, nature of problem, and cover or clearance to be employed, plus special precautions to be observed.
Type of field coating:
For pipe (if not factory coated)
For girth welds and fittings
Type of test of coating before backfill
Type of test of coating after backfill
Proposed cathodic protection
