New York Codes, Rules and Regulations
Title 1 - DEPARTMENT OF AGRICULTURE AND MARKETS
Chapter VI - Food Control
Subchapter G - Inspection of Meat, Meat Products and Poultry (Article 5-B Agriculture and Markets Law)
Article 1 - Meat and Meat Products
Part 318 - Entry Into Official Establishments; Reinspection And Preparation Of Products
Section 318.11 - Canning with heat processing and hermetically sealed containers; cleaning containers; closure; code marking; heat processing; incubation

Universal Citation: 1 NY Comp Codes Rules and Regs ยง 318.11

Current through Register Vol. 46, No. 39, September 25, 2024

(a) Containers which are intended to be hermetically sealed shall be cleaned thoroughly immediately before filling, and precaution must be taken to avoid soiling the inner surfaces subsequently. However, cans in which lard is to be hermetically sealed may be examined immediately before filling and if found to be acceptably clean by a department employee need not be washed.

(b) Containers of metal, glass, or other material shall be washed in an inverted position with a water spray. The nozzle on the spray attachment shall be of such design and the water delivered with such pressure as will effectively rinse all of the inner surface of each container. Such containers shall not contain an accumulation of water when received at the filling station. In lieu of cleaning with water, the use of efficient jet-vacuum type equipment for cleaning containers is permitted, immediately prior to filling.

(c) Nothing less than perfect closure is acceptable for hermetically sealed containers. Heat processing shall follow promptly after closing.

(d) Careful inspection shall be made of the containers by competent establishment employees immediately after closing, and containers which are defectively filled or defectively closed or show inadequate vacuum shall not be processed until the defect has been corrected. The containers shall again be inspected by establishment employees when they have cooled sufficiently for handling after processing by heating. The contents of defective containers shall be condemned unless correction of the defect is accomplished within six hours following the sealing of the containers or completion of the heat processing, as the case may be, except that:

(1) if the defective condition is discovered during an afternoon run, the cans of product may be held in coolers at a temperature not exceeding 38 degrees Fahrenheit under conditions that will promptly and effectively chill them until the following day when the defect may be corrected;

(2) short vacuum or overstuffed cans of product which have not been handled in accordance with paragraph (1) may be incubated under department supervision, after which the cans shall be opened and the sound product passed for food; and

(3) short vacuum or overstuffed cans of product of a class required to be labeled "Perishable, Keep Under Refrigeration" and which have been kept under adequate refrigeration since processing may be opened and the sound product passed for food.

(e) Canned products shall not be passed unless after cooling to atmospheric temperature, they show the external characteristics of sound cans, that is, the cans shall not be overfilled; they shall have concave sides, excepting the seam side, and all ends shall be concave; there shall be no bulging; the sides and ends shall conform to the product; and there shall be no slack or loose tin.

(f) All canned products shall be plainly and permanently marked on the containers by code or otherwise with the identity of the contents and date of canning. The code used and its meaning shall be on record in the office of the inspector in charge. If calendar dating is used, it must be accompanied by an explanatory statement, as provided in section 317.8(b)(32)(ii) of this Article.

(g) Canned product must be processed at such temperature and for such period of time as will assure keeping without refrigeration under usual conditions of storage and transportation when heating is relied on for preservation, with the exception of those canned product which are processed without steam-pressure cooking by permission of the commissioner in specific cases and labeled "Perishable, Keep Under Refrigeration".

(h) Lots of canned product shall be identified during their handling preparatory to heat processing by tagging the baskets, cages, or cans with a tag which will change color on going through the heat processing or by other effective means so as to positively preclude failure to heat process after closing.

(i) Facilities shall be provided by the operator of the official establishment for incubation of representative samples of fully processed canned product. The incubation shall consist of holding the canned product for the periods of time and at the temperatures prescribed in paragraph (4) of this subdivision.

(1) Incubation test shall be made to the extent required by the officer in charge. The extent to which incubation tests shall be required depends on conditions such as the record of the official establishment in conducting canning operations, the extent to which the establishment furnishes competent supervision and inspection in connection with the canning operations, the character of the equipment used, and the degree to which such equipment is maintained at maximum efficiency. Such factors shall be considered by the officer in charge in determining the extent of incubation testing at a particular establishment.

(2) In the event of failure by an official establishment to provide suitable facilities for incubation of test samples, the officer in charge may require holding of the entire lot under such conditions and for such period of time as may, in his discretion, be necessary to establish the stability of the product.

(3) The officer in charge may permit lots of canned product to be shipped from the official establishment prior to completion of sample incubation when he has no reason to suspect unsoundness in the particular lots, and under circumstances which will assure the return of the product to the establishment for reinspection should such action be indicated by the incubation results.

(4) Incubation shall consist of holding the samples at 95 degrees (+-2° F.) for no less than 10 days; except
(i) Samples of firmly packed products such as luncheon meat, and products with high fat content, such as chorizos packed in lard, and products weighing three pounds or more shall be held at 95 degrees (+-2° F.) for no less than 20 days.

(ii) Samples of products composed of chunks or patties of meat in a medium or sauce wherein the pH of the meat component and the medium or sauce are significantly different shall be incubated at 95 degrees (+-2° F.) for no less than 30 days.

Disclaimer: These regulations may not be the most recent version. New York may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.