New Mexico Administrative Code
Title 20 - ENVIRONMENTAL PROTECTION
Chapter 5 - PETROLEUM STORAGE TANKS
Part 105 - CERTIFICATION OF TANK INSTALLERS AND JUNIOR INSTALLERS; REQUIREMENTS FOR TESTERS
Section 20.5.105.515 - INSTALLER DUTIES AND OBLIGATIONS

Universal Citation: 20 NM Admin Code 20.5.105.515

Current through Register Vol. 35, No. 6, March 26, 2024

A. No person shall agree to perform installation, replacement, repair or modification services unless the person is or employs a certified installer competent to perform the particular installation, replacement, repair or modification involved.

B. A certified installer shall have adequate knowledge of appropriate materials, technical requirements and installation, replacement, repair or modification procedures for any storage tank system that the installer undertakes to install, replace, repair or modify. A certified installer shall not perform any installation, replacement, repair or modification, or affix an installer signature or certification number to any installation, replacement, repair or modification for which the installer lacks competence.

C. A certified installer shall:

(1) exercise responsible supervisory control over any installation, replacement, repair or modification undertaken;

(2) at a minimum, be physically present on-site at all critical junctures in the installation, replacement, repair or modification; and

(3) give notice as required by these regulations, 20.5 NMAC.

D. A certified installer shall not certify to an owner or operator of a storage tank system that an installation, replacement, repair or modification is complete unless the installation, replacement, repair, or modification complies with the New Mexico Hazardous Waste Act, Sections 74-4-1 through 74-4-14 NMSA 1978, and the petroleum storage tank regulations promulgated pursuant to the act, 20.5 NMAC. The certified installer is responsible for the accuracy of any representations made to the owner or operator.

E. Certified installers have a duty to report to the department any and all suspected or confirmed releases, as those terms are used in 20.5.118 NMAC, detected at a site or the surrounding area by the installer or persons working under the installer's supervisory control, as required by 20.5.118 NMAC.

F. Certified installers shall not perform any installation, replacement, repair, modification or removal without providing notice as required by the provisions of 20.5 NMAC, except for emergency repairs as described in 20.5.107 NMAC and 20.5.110 NMAC, and defined in 20.5.101 NMAC. Certified installers shall not perform any activity described as a critical juncture in 20.5.105 NMAC, without providing the 24-hour notice required by that part, except for emergency repairs.

G. Certified installers shall comply with all of the provisions of the petroleum storage tank regulations, 20.5 NMAC.

Disclaimer: These regulations may not be the most recent version. New Mexico may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.