New Mexico Administrative Code
Title 20 - ENVIRONMENTAL PROTECTION
Chapter 2 - AIR QUALITY (STATEWIDE)
Part 62 - MUNICIPAL WASTE COMBUSTION
Section 20.2.62.201 - EMISSION LIMITS
Universal Citation: 20 NM Admin Code 20.2.62.201
Current through Register Vol. 35, No. 18, September 24, 2024
A. Emission Limits: The owner or operator shall not cause or allow any emission limit in Table 1 (20.2.62.213 NMAC) to be exceeded.
B. Compliance:
(1) Compliance with emission limits for
sulfur dioxide and nitrogen dioxide shall be determined by continuous emission
monitor measurements as calculated in the form of 24-hour daily
averages.
(2) Compliance with the
emission limit for carbon monoxide shall be determined by continuous emission
monitor measurements as calculated in the form of 4-hour block
averages.
(3) Compliance with the
emission limits for particulate matter, PCDD/PCDF, total hydrocarbon, hydrogen
chloride and metals shall be determined by manual tests conducted in accordance
with 20.2.62.204 NMAC. For metals, the percent removal shall be calculated as
the percent difference between the measured concentrations at the inlet and
outlet of the air pollution control system.
(4) Compliance with the opacity limit in
Table 1 (20.2.62.213 NMAC) shall be determined by continuous emission monitor
measurements and 40 CFR Part 60, Appendix A, Method 9 as calculated in the form
of 6-minute averages.
Disclaimer: These regulations may not be the most recent version. New Mexico may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
