New Mexico Administrative Code
Title 19 - NATURAL RESOURCES AND WILDLIFE
Chapter 8 - COAL MINING
Part 25 - SPECIAL PERFORMANCE STANDARDS - MOUNTAIN TOP REMOVAL
Section 19.8.25.2500 - MOUNTAIN TOP REMOVAL: PERFORMANCE STANDARDS

Universal Citation: 19 NM Admin Code 19.8.25.2500

Current through Register Vol. 35, No. 24, December 23, 2024

Surface coal mining activities may be conducted under a variance from the requirement of this part for restoring affected areas to their approximate original contour, if:

A. the director grants the variance under a permit in accordance with 19.8.10.1001 NMAC;

B. the activities involve the mining of an entire coal seam running through the upper fraction of a mountain, ridge, or hill, by removing all of the overburden and creating a level plateau or gently rolling contour with no highwalls remaining;

C. an industrial, commercial, agricultural, residential, or public facility (including recreational facilities) use is proposed and approved for the affected land;

D. the alternative land use requirements of 19.8.20.2073 NMAC are met;

E. all applicable requirements of this part, the act and 19.8.1 through 19.8.35 NMAC, other than the requirement to restore affected areas to their approximate original contour, are met;

F. an outcrop barrier of sufficient width, consisting of the toe of the lowest coal seam, and its associated overburden, are retained to prevent slides and erosion, except that the director may permit an exemption to the retention of the coal barrier requirement if the following conditions are satisfied:

(1) the proposed mine site was mined prior to May 3, 1978, and the toe of the lowest seam has been removed;

(2) a coal barrier adjacent to a head-of-hollow fill may be removed after the elevation of a head-of-hollow fill attains the elevation of the coal barrier if the head-of-hollow fill provides the stability otherwise ensured by the retention of a coal barrier; or

(3) the operator demonstrates to the director, and the director determines that no outcrop barrier is necessary to prevent slides and erosion.

G. the final graded slopes on the mined area are less than 1v:5h, so as to create a level plateau or gently rolling configuration, and the outslopes of the plateau do not exceed 1v:2h except where engineering data substantiates, and the director finds, in writing, and includes in the permit under 19.8.10.1001 NMAC, that a minimum static safety factor of 1.5 will be attained;

H. the resulting level or gently rolling contour is graded to drain inward from the outslope, except at specified points where it drains over the outslope in stable and protected channels. The drainage shall not be through or over a valley fill or head-of-hollow fill;

I. natural watercourse below the lowest coal seam mined are not damaged;

J. all waste and acid-forming or toxic-forming materials, including the strata immediately below the coal seam, are covered with non-toxic spoil to prevent pollution and achieve the approved postmining land use; and

K. spoil is placed on the mountaintop bench as necessary to achieve the postmining land use approved under Paragraphs (3) and (4) of Subsection A of 19.8.25.2500 NMAC. All excess spoil material not retained on the mountaintop shall be placed in accordance with 19.8.20.2020 and 2034 through 2037 NMAC.

Disclaimer: These regulations may not be the most recent version. New Mexico may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.