New Mexico Administrative Code
Title 19 - NATURAL RESOURCES AND WILDLIFE
Chapter 25 - ADMINISTRATION AND USE OF WATER - GENERAL PROVISIONS
Part 3 - MAPS AND PLANS
Section 19.25.3.9 - SCALE AND SIZE

Universal Citation: 19 NM Admin Code 19.25.3.9

Current through Register Vol. 35, No. 18, September 24, 2024

A. Maps for all basins except the Mimbres and Animas shall be seventeen (17) inches wide and twenty-three (23) inches long on the trim lines with margins of one (1) inch on the top, one-half (1/2) inch on the right side and bottom, and one and a half (1 1/2) inches on the left or long side for binding purposes. The map shall have a scale of one (1) inch equals four hundred (400) feet, unless otherwise specified by the state engineer. See page 36 [now 19.25.3.16 NMAC] for sample plat. If more than one sheet is required, they shall be properly numbered in sequence (Example - Sheet 1 of 3 sheets).

B. Mimbres and Animas basins: Maps for the Mimbres and Animas basins shall be fourteen (14) inches wide and seventeen (17) inches long on trim lines with margins of one-half (1/2) inch on the top, right side and bottom, and one and a half (1 1/2) inches on the left or long side for binding purposes. The map shall have a scale of one (1) inch equals five hundred (500) feet.

Disclaimer: These regulations may not be the most recent version. New Mexico may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.