New Jersey Administrative Code
Title 7 - ENVIRONMENTAL PROTECTION
Chapter 18 - REGULATIONS GOVERNING THE CERTIFICATION OF LABORATORIES AND ENVIRONMENTAL MEASUREMENTS
Subchapter 5 - CHEMICAL TESTING
Section 7:18-5.3 - Required use of DSAMs
Universal Citation: NJ Admin Code 7:18-5.3
Current through Register Vol. 56, No. 18, September 16, 2024
(a) In performing chemical analysis of a regulatory sample (including, without limitation, analysis of a PT sample by a laboratory that is applying to become certified), a laboratory shall use only:
1. A DSAM from the applicable Category listed in
7:18-5.1(a) for which
the laboratory is certified or is applying to become certified; or
2. An applicable ATP approved by the Department
pursuant to 7:18-2.20 for the laboratory and, if
applicable, for the facility in question.
(b) The requirements of (a) above do not apply to the analysis of a non-regulatory sample, if the requirements of 7:18-2.22(b) are satisfied.
(c) If a laboratory applies for certification for an analytical method under the Clean Air Program that requires other analytical methods to be performed as part of the analysis, the laboratory shall also apply for certification for all of the required methods.
Disclaimer: These regulations may not be the most recent version. New Jersey may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
