New Jersey Administrative Code
Title 7 - ENVIRONMENTAL PROTECTION
Chapter 18 - REGULATIONS GOVERNING THE CERTIFICATION OF LABORATORIES AND ENVIRONMENTAL MEASUREMENTS
Subchapter 2 - PROGRAM PROCEDURES AND REQUIREMENTS
Section 7:18-2.22 - Required use of DSAMs

Universal Citation: NJ Admin Code 7:18-2.22

Current through Register Vol. 56, No. 18, September 16, 2024

(a) In analyzing a regulatory sample, a certified environmental laboratory shall use only:

1. A DSAM from an applicable category for which the laboratory is certified; or

2. An ATP approved by the Department for the laboratory and, if applicable, for the facility in question.

(b) The requirements of (a) above do not apply to an analysis for which all of the requirements of (b)1 through 3 below are satisfied:

1. The client has provided a written statement confirming that the analysis will not be used for regulatory purposes;

2. The laboratory's report of the results of the analysis prominently displays the following statement: "This analysis is not to be used for the purpose of determining compliance with the Safe Drinking Water Act, the Water Pollution Control Act, the portion of the Radiation Protection Act governing radon and radon progeny, the Solid Waste Management Act, the Industrial Site Recovery Act, or the Spill Compensation and Control Act; any regulation or order issued pursuant to any of those statutes; or the USEPA's CERCLA Contract Laboratory Program."; and

3. The laboratory meets the requirements of 7:18-2.15(d)3.

Disclaimer: These regulations may not be the most recent version. New Jersey may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.