New Jersey Administrative Code
Title 5 - COMMUNITY AFFAIRS
Chapter 21 - RESIDENTIAL SITE IMPROVEMENT STANDARDS
Subchapter 4 - STREETS AND PARKING
Section 5:21-4.17 - Curb construction standards

Universal Citation: NJ Admin Code 5:21-4.17

Current through Register Vol. 56, No. 18, September 16, 2024

(a) Construction specifications for acceptable curb types of granite block and concrete are shown in Figure 4.1 below.

1. Where granite block curb is used, a transition from granite block to concrete shall be provided at all accessible sidewalk ramps or curb cuts.

2. Concrete gutters with a minimum width of four inches may be installed to separate the curb from the pavement.

(b) The standard concrete curb section used shall be a maximum of 20 feet in length, with a scored joint every 10 feet. All concrete used for curbs or combination curbs and gutters shall be prepared in accordance with the requirements, by class of concrete, of the New Jersey Department of Transportation, Standard Specifications for Road and Bridge Construction, effective at the time of preparation. Where bituminous concrete pavement is used for the road surface, the curb and/or gutter shall be constructed first.

(c) Where drainage inlets are constructed but curbs are not required, curbing must be provided at least 10 feet on each side of the inlet, set back one foot from the extension of the pavement edge.

(d) Where mountable curb is used, vertical curbing shall be provided at least 10 feet on each side of drainage inlets.

Data in image

Data in image

Data in image

Data in image

Data in image

Data in image

Disclaimer: These regulations may not be the most recent version. New Jersey may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.