New Jersey Administrative Code
Title 13 - LAW AND PUBLIC SAFETY
Chapter 62 - MOTOR VEHICLE RACE TRACK RULES
Subchapter 6 - MOTORCYCLE AND QUAD VEHICLES RACING EVENTS (OVAL RACING)
Section 13:62-6.3 - Exceptions

Universal Citation: NJ Admin Code 13:62-6.3

Current through Register Vol. 56, No. 18, September 16, 2024

(a) Hubrail posts constructed for use on motorcycle tracks shall be no higher than the hubrail planking.

(b) Hubrails constructed for use on motorcycle tracks shall consist of safety rails two feet high, constructed of two two-inch by 12-inch planks, on four-inch by four-inch stanchions spaced not more than six feet apart, and so embedded in the ground that they will not pull out if struck.

(c) As an alternative to the two-inch by 12-inch planks, two planks made of marine plywood, 3/4 inches thick and 12 inches wide may be used on motorcycle tracks. These rails shall be backed up either by a wire cable similar to the wire cable used on automobile hubrails, except that it need not exceed 1/2 inch in diameter, or in the alternative, a mound of packed earth shall be constructed in the back of the safety rail at least 18 inches high, and tapering to the ground level between the rail and the spectators.

Disclaimer: These regulations may not be the most recent version. New Jersey may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.