New Jersey Administrative Code
Title 13 - LAW AND PUBLIC SAFETY
Chapter 20 - ENFORCEMENT SERVICE
Subchapter 33 - INSPECTION STANDARDS AND TEST PROCEDURES TO BE USED BY LICENSED PRIVATE INSPECTION FACILITIES
Section 13:20-33.14 - Commercial vehicle inspection: identification lights
Current through Register Vol. 56, No. 6, March 18, 2024
(a) Identification lights are used in groups of three in a horizontal row which show to the front and rear of a motor vehicle, respectively, and have light centers spaced not less than six inches nor more than 12 inches apart.
(b) A truck or bus 80 inches or more in width manufactured after January 1, 1965, shall be equipped with three amber identification lights on the front of the vehicle and three red identification lights on the rear of the vehicle. If the cab is not more than 42 inches wide at the front roof line, a single identification light at the centerline of the cab shall be deemed to comply with the requirements for front identification lights.
(c) Identification lights shall be of a type approved as meeting the standards of the United States Department of Transportation or, for motor vehicles manufactured prior to the adoption of such standards, the standards of the Society of Automotive Engineers. The letters "SAE" and the letters "P" or "P2," along with the manufacturer's name and trademark, are on the lens of such lights in most cases.
(d) Every identification light shall be permanently and securely mounted on a permanent part of the vehicle as close as practical to the vertical centerline and the top of the vehicle. No part of front identification lights or their mountings shall extend below the top of the vehicle windshield.
