New Hampshire Code of Administrative Rules
Saf - Department of Safety
Subtitle Saf-C - Commissioner, Department of Safety
Chapter Saf-C 3200 - OFFICIAL MOTOR VEHICLE INSPECTION REQUIREMENTS
Part Saf-C 3226 - TRUCKS AND BUSES
Section Saf-C 3226.25 - Brake Drum/Disc-Measurements

Universal Citation: NH Admin Rules Saf-C 3226.25

Current through Register No. 40, October 3, 2024

A vehicle shall be rejected if:

(a) The inside diameter of the brake drum is greater than the maximum diameter stamped on the drum or manufacturer's specifications;

(b) The maximum diameter is 0.090 inches greater than the original drum diameter, for 14 1/8 inch and smaller unmarked drums;

(c) The maximum diameter is 0.120 inches greater than the original drum diameter, for unmarked drums over 14 1/8 inch; or

(d) Any brake drum or disc:

(1) Shows evidence of mechanical damage other than wear;

(2) Has contaminants including but not limited to: rust, pitting, delamination, oil, grease, or any other substance that would affect proper brake operation;

(3) Has cracks on the friction surface extending to the open edge or on the outside of the drum, particularly at the drum mounting area;

(4) Has a broken disc;

(5) Has cracks on the friction surface extending to the open edge on a disc;

(6) Has defective grease retainers;

(7) Is worn beyond the manufacturer's specifications; or

(8) Has thickness less than the minimum which is stamped on the assembly.

(See Revision Notes at chapter heading Saf-C 3200) #8915, eff 6-22-07

Disclaimer: These regulations may not be the most recent version. New Hampshire may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.