New Hampshire Code of Administrative Rules
Saf - Department of Safety
Subtitle Saf-C - Commissioner, Department of Safety
Chapter Saf-C 1300 - SCHOOL BUS TRANSPORTATION
Part Saf-C 1306 - OPERATION OF SCHOOL BUS
Section Saf-C 1306.09 - Railroad Grade Crossing Procedure
Universal Citation: NH Admin Rules Saf-C 1306.09
Current through Register No. 40, October 3, 2024
(a) Pursuant to RSA 265:50, I, each school bus driver shall stop at all railroad grade crossings, except as provided in RSA 265:50, II.
(b) Each school bus driver shall complete the following procedure in the stated orderat each railroad grade crossing:
(1) When approaching the crossing, slow down,
shift to a lower gear if in a manual transmission bus and test the
brakes;
(2) Activate the hazard
lights approximately 200 feet from the railroad grade crossing;
(3) Move as far to the right of the road as
practical in the desired lane of travel;
(4) Turn off the master switch, if
applicable;
(5) Scan surroundings
and check for traffic behind the school bus;
(6) Locate an escape route in the event of a
brake failure or other emergency;
(7) At the crossing itself, completely stop
the bus at least 15 feet, but no more than 50 feet, from the nearest rail and,
if it is a multitrack crossing, stop only before the first set of
tracks;
(8) Place the transmission
in "park" and if no "park", place it in "neutral', press down on the service
brake and set the parking brake;
(9) Open the service door and the driver's
window to look in both directions for approaching trains;
(10) Shut off noisy equipment, instruct
passengers to be quiet and listen for an approaching train;
(11) Check the crossing signals again and
when it is safe to do so, close the entrance door;
(12) Assess the space on the other side of
the tracks to determine if there is sufficient room for the school bus plus an
additional 15 feet should there be an intersection with or without traffic
controls that may require the bus to stop;
(13) When it is safe to do so, place the
transmission in the appropriate gear, release the parking brake and proceed
across the tracks without shifting gears, until the bus completely clears the
tracks;
(14) At a multi-track
crossing, when certain that there is no train approaching on any of the tracks,
proceed across all of the tracks until the bus completely clears all of the
tracks;
(15) If a crossing gate
comes down after the bus has started across the tracks, do not stop but instead
proceed across the tracks even if it means the gate will be broken;
and
(16) After the rear of the bus
is 15 feet beyond the last rail, turn off the hazard lights and turn on the
master switch, if applicable.
(c) Prior to permitting a new or substitute driver to drive a school bus, each employer shall notify the new or substitute driver of:
(1) The procedures set forth in (a)
and (b) above; and
(2) Any
characteristics of railroad grade crossings unique to the particular school bus
route.
#4873, eff 07-24-90; ss by #6297, eff 7-23-96; ss by #8122, INTERIM, eff 7-17-04, EXPIRES: 1-13-05; ss and moved by #8248, eff 1-4-05 (from Saf-C 1316.09)
Disclaimer: These regulations may not be the most recent version. New Hampshire may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.