New Hampshire Code of Administrative Rules
Lab - Commissioner, Department of Labor
Chapter Lab 1400 - SAFETY AND HEALTH OF EMPLOYEES
Part Lab 1403 - RULES FOR EMPLOYEE SAFETY AND HEALTH
Section Lab 1403.09 - Chains, Cables, Ropes, and Hooks

Universal Citation: NH Admin Rules Lab 1403.09

Current through Register No. 40, October 3, 2024

The employer shall ensure compliance with the following requirements:

(a) Chains, cables, ropes, and hooks shall be visually inspected daily by a competent person, for deformation, cracks, excessive wear, twists and stretch, and defective gear shall be replaced or repaired;

(b) Hoist ropes on crawler, locomotive, and truck cranes shall be free from kinks or twists and shall not be wrapped around the load; and

(c) All U-bolt wire rope clips on hoist ropes shall be installed so that the U-bolt is in contact with the short or nonload-carrying end of the rope. Clips shall be installed in accordance with the clip manufacturer's recommendation. All nuts on newly installed clips shall be retightened after the first hour of use.

#4118 eff 8-22-86, EXPIRED: 8-22-92

New. #6684, eff 2-4-98, EXPIRED: 2-4-06

New. #8606, INTERIM, eff 4-12-06, EXPIRED: 10-09-06 (formerly Lab 1403.10)

New. #8796, eff 1-11-07

Disclaimer: These regulations may not be the most recent version. New Hampshire may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.