Administrative Rules of Montana
Department 24 - LABOR AND INDUSTRY
Chapter 24.351 - BUILDING AND COMMERCIAL MEASUREMENTS BUREAU
Subchapter 24.351.2 - Weighing and Measuring Devices
Rule 24.351.211 - FEES FOR TESTING AND CERTIFICATION
Universal Citation: MT Admin Rules 24.351.211
Current through Register Vol. 18, September 20, 2024
(1) The following fees shall apply to the testing of all devices subject to these rules:
(a) PA Meters (20 GPM or less)
$10.00
(b) PB Meters (20 GPM-130
GPM) $30.00
(c) PC Meters (above
130 GPM) $30.00
(d) PD Meters
(Liquified Petroleum Gas) $50.00
(e) SA/S1 Scales (499 LB or less)
$20.00
(f) SB/S2 Scales (500
LB-1,999 LB) $30.00
(g) SC/S3
Scales (2,000 LB-7,999 LB) $35.00
(h) SD/S4 Scales (8,000 LB-60,000 LB)
$150.00
(i) SE/S5 Scales (60,000 LB
or more) $150.00
(2) A reinspection of a rejected device shall not incur the testing and certification fee.
(3) Special inspections are not required by statute and only occur upon request to the bureau. The fees for special inspections are as follows:
(a) units
over 5000 pounds of testing weights, $2.50 per mile, measured by the distance
the bureau's employee travels in connection with the special inspection;
(b) all other units, $1.25 per
mile, as measured by the distance the bureau's employee travels in connection
with the special inspection; and
(c) time for testing by inspection, $75 per
hour.
(4) Where fees are not paid within 30 days after any inspection completed by the bureau, the bureau may seal and remove the device from service, until the fees have been paid.
AUTH: 30-12-202, MCA; IMP: 30-12-202, 30-12-203, MCA
Disclaimer: These regulations may not be the most recent version. Montana may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
