Administrative Rules of Montana
Department 23 - JUSTICE
Chapter 23.3 - MOTOR VEHICLE DIVISION
Subchapter 23.3.9 - Alcohol Analysis
Rule 23.3.960 - APPLICATION FOR CERTIFICATION FOR AN IGNITION INTERLOCK DEVICE
Universal Citation: MT Admin Rules 23.3.960
Current through Register Vol. 6, March 22, 2024
(1) A manufacturer must submit an application to the Motor Vehicle Division requesting a letter of certification for an IID.
(2) The manufacturer must:
(a) complete the
application for certification for an IID;
(b) give the manufacturer name, physical,
mailing, and e-mail addresses, and phone number;
(c) give the manufacturer and, if applicable,
the manufacturer's representative's name, physical, mailing, and e-mail
addresses, and phone number;
(d)
give a detailed description of the IID, including the instruction,
installation, and troubleshooting manuals;
(e) give written verification that the IID
complies with all applicable standards set under the Model Specifications of
the National Highway Traffic Safety Administration Model Specifications for
Breath Alcohol Ignition Interlock Devices 78 FR 26849-26867 (2013), Montana
Code Annotated, and ARM Title 23, including ARM 23.3.957;
(f) give a statement that:
(i) the applicant and their employees will
cooperate with the Motor Vehicle Division at all times, including its
inspection of the manufacturer or vendor's installation, service, repair,
calibration, use, removal, or performance of IID;
(ii) the applicant agrees to give all
downloaded IID data, reports, and information related to the IID to the Motor
Vehicle Division in an approved electronic format;
(iii) the applicant or their employees agree
to give testimony relating to any aspect of the installation, service, repair,
calibration, use, removal, or performance of the ignition interlock at no cost
on behalf of the State of Montana or any other political subdivision;
(g) give the IID configuration
profile;
(h) submit a report from
an International Organization For Standardization certified testing laboratory
documenting:
(i) the test results of the
IID;
(ii) the test results must be
dated on or after May 8, 2013;
(iii) the manufacturing date of the IID test
samples;
(iv) the serial numbers
and firmware and software versions of the devices tested;
(v) all technical specifications describing
the accuracy and reliability of the device;
(vi) the test results must verify that the
proposed IID meets or exceeds the model specifications of the National Highway
Traffic Safety Administration Model Specifications for Breath Alcohol Ignition
Interlock Devices 78 FR 26849-26867 (2013) and any additional requirements
established by the State of Montana;
(vii) authorizing signatures, and attestation
by the corporate officers of the independent laboratory indicating the accuracy
of the reported results;
(i) the applicant must bear all costs
associated with the laboratory analysis and required reporting;
(j) if specifically requested by the Motor
Vehicle Division, give two IIDs for field and laboratory testing;
(k) give the alcohol reference value and type
of calibration device used to check the IID.
AUTH: 61-8-1025, MCA; IMP: 61-8-1025, MCA
Disclaimer: These regulations may not be the most recent version. Montana may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.