Minnesota Administrative Rules
Pollution Control Agency
7080 - INDIVIDUAL SUBSURFACE SEWAGE TREATMENT SYSTEMS
7080.1910 - TANK STRENGTH.

Universal Citation: MN Rules 7080.1910
7080.1910 TANK STRENGTH.
Subpart 1. Requirements.

Tanks, fittings, risers, and apertures must:

A. be capable of supporting long-term vertical loads for the conditions in which the tank will be placed. These loads include, but are not limited to, saturated soil load, based on 130 pounds per cubic foot;

B. be capable of withstanding a lateral load for the conditions the tank will be placed;

C. with proper maintenance and venting, not be subject to failure due to corrosion and degradation from sewage or sewage gases, including risers and maintenance hole covers; and

D. be structurally capable of withstanding exposure and stresses from freezing conditions.

Subp. 2. Poured-in-place concrete tanks.

Poured-in-place concrete tanks must be designed to meet each requirement of subpart 1 and be designed by a Minnesota licensed professional engineer.

Statutory Authority:

MS s 115.03; 115.55

History:

32 SR 1347

Published Electronically:

October 10, 2013

Disclaimer: These regulations may not be the most recent version. Minnesota may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.