Minnesota Administrative Rules
Agency 167 - Pollution Control Agency
Chapter 7017 - MONITORING AND TESTING REQUIREMENTS
PERFORMANCE TESTS
Part 7017.2001 - Repealed

Universal Citation: MN Rules 7017.2001

Current through Register Vol. 49, No. 13, September 23, 2024

Subpart 1. Applicability.

For the purpose of conducting a performance test as required by an applicable requirement or compliance document or as a data submittal engineering test, parts 7017.2001 to 7017.2060 apply unless more stringent requirements or equivalent procedures are mandated by an applicable requirement or compliance document. However, for the purpose of conducting a data submittal engineering test, part 7017.2025 does not apply and the operating conditions for the test shall be defined in the test plan. If the commissioner determines that a data submittal engineering test was not conducted at appropriate operating conditions for the type of data submittal, the commissioner shall declare the results invalid for their intended purpose unless the results can be adjusted and made representative using a scaling factor or engineering judgment or, in the case of a permit application, the permit contains an operating limit based on the tested conditions.

Subp. 2. [Repealed, 41 SR 763]

Statutory Authority: MS s 116.07

Disclaimer: These regulations may not be the most recent version. Minnesota may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.