Minnesota Administrative Rules
Agency 167 - Pollution Control Agency
Chapter 7011 - STANDARDS FOR STATIONARY SOURCES
IRON AND STEEL PLANTS
Part 7011.2010 - PERFORMANCE TEST METHODS
Universal Citation: MN Rules 7011.2010
Current through Register Vol. 49, No. 13, September 23, 2024
Unless another method is approved by the agency, an owner or operator required to submit performance tests for an iron and steel plant must use the following test methods to demonstrate compliance:
A. Method 1 for sample and velocity traverses;
B. Method 2 for volumetric flow rate;
C. Method 3 for gas analysis;
D. Method 5 for concentration of filterable particulate matter and associated moisture content.
Statutory Authority: MS s 116.07
Disclaimer: These regulations may not be the most recent version. Minnesota may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
