Minnesota Administrative Rules
Agency 158 - Natural Resources Department
Chapter 6130 - FERROUS METALLIC MINERAL MINING
TACONITE AND IRON ORE RECLAMATION STANDARDS
Part 6130.2400 - STANDARDS FOR ROCK, LEAN ORE, AND COARSE TAILINGS STOCKPILES
Universal Citation: MN Rules 6130.2400
Current through Register Vol. 49, No. 13, September 23, 2024
Rock, lean ore, and coarse tailings stockpiles, unless they are an integral part of a tailings impoundment, shall be designed and constructed according to either of the following standards:
A. The final exterior slopes shall consist of benches and lifts as follows:
(1) no lift
shall exceed 30 feet in height;
(2)
no bench width shall be less than 30 feet wide, measured from the crest of the
lower lift to the toe of the next lift;
(3) the sloped area between benches shall be
no steeper than the angle of repose;
(4) benches shall be designed and constructed
to control runoff;
(5) when
vegetation is required pursuant to part 6130.3600, subpart 2, item D, the
sloped areas between benches shall be prepared to support vegetation;
and
(6) when the sloped area
between benches is covered with surface overburden and vegetated, lifts may be
raised to a maximum of 40 feet.
B. Based upon acceptable research the commissioner shall approve other measures which satisfy part 6130.2000.
Statutory Authority: MS s 93.47
Disclaimer: These regulations may not be the most recent version. Minnesota may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
