Minnesota Administrative Rules
Agency 151 - Labor and Industry Department
Chapter 5205 - OCCUPATIONAL SAFETY AND HEALTH STANDARDS
MAINTENANCE AND REPAIR OF BUILDINGS AND EQUIPMENT
Part 5205.0700 - WIRE ROPE CLIPS
Universal Citation: MN Rules 5205.0700
Current through Register Vol. 49, No. 13, September 23, 2024
Subpart 1. Location of U-bolts.
Wire rope clips attached with U-bolts shall have the U-bolts on the dead or short end of the rope.
Subp. 2. Clip construction.
Clips shall be made of drop forged steel. All nuts on the clip bolts of a newly installed rope shall be retightened after the first hour of service.
Subp. 3. Clip spacing.
Spacing and number of clips shall be in accordance with the table below:
| Rope Diameter (inches) | Number of Clips Drop Forged | Minimum Spacing (inches) |
| 3/16 | 2 | 1-1/8 |
| 1/4 | 2 | 1-1/2 |
| 5/16 | 2 | 1-7/8 |
| 3/8 | 2 | 2-1/4 |
| 7/16 | 2 | 2-5/8 |
| 1/2 | 3 | 3 |
| 5/8 | 3 | 3-3/4 |
| 3/4 | 4 | 4-1/2 |
| 7/8 | 4 | 5-1/4 |
| 1 | 5 | 6 |
| 1-1/8 | 6 | 6-1/4 |
| 1-1/4 | 6 | 7-1/2 |
| 1-3/8 | 7 | 8-1/4 |
| 1-1/2 | 7 | 9 |
Statutory Authority: MS s 182.655
Disclaimer: These regulations may not be the most recent version. Minnesota may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
