Minnesota Administrative Rules
Agency 151 - Labor and Industry Department
Chapter 1341 - ACCESSIBILITY FOR BUILDINGS AND FACILITIES
Part 1341.0104 - A117.1 SECTION 104, CONVENTIONS
Universal Citation: MN Rules 1341.0104
Current through Register Vol. 49, No. 13, September 23, 2024
Subpart 1. A117.1 Section 104.2, Dimensions.
A117.1 Section 104.2 is amended to read as
follows:
104.2
Dimensions. Dimensions that are not stated as "maximum" or "minimum" are
absolute. All dimensions are subject to conventional industry tolerances except
where the dimension is stated as a range with specific minimum and maximum end
points.
Subp. 2. Section 104.6.
A117.1 Section 104
is amended by adding a Section to read as follows:
104.6
Calculation of
Percentages. Where the required number of elements or facilities to be
provided is determined by calculations of ratios or percentages and remainders
or fractions result, the next greater whole number of such elements or
facilities shall be provided. Where the determination of the required size or
dimension of an element or facility involves ratios or percentages, rounding
down for values less than one-half shall be permitted.
Statutory Authority: MS s 16B.37; 16B.59 to 16B.76; 326B.101 to 326B.194
Disclaimer: These regulations may not be the most recent version. Minnesota may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
