Minnesota Administrative Rules
Agency 144 - Health Department
Chapter 4725 - WELLS AND BORINGS
WELL AND BORING GENERAL CONSTRUCTION AND USE REQUIREMENTS
Part 4725.3750 - REPAIR, CORRECTION, OR SEALING OF WELLS AND BORINGS

Universal Citation: MN Rules 4725.3750

Current through Register Vol. 49, No. 13, September 23, 2024

Subpart 1. Repair, correction, or sealing required.

The property owner must:

A. have a defective part of a well or boring repaired, including a broken, punctured, or otherwise defective or unserviceable casing, screen, fixture, seal, connection, cover, or cap;

B. eliminate injection or disposal of wastes, surface drainage, or flood water, directly entering a well or boring; and

C. disconnect a cross-connection between a well or boring and a public water system unless approved by the public water supplier and protected with an air gap or backflow prevention device according to UPC sections 603.0 to 603.5.23.4 as incorporated by part 4714.0050.

A well or boring not repaired or corrected must be permanently sealed.

Subp. 2. Materials.

Materials used in maintenance, replacement, or repair must meet the requirements of this chapter for new installation.

Subp. 3. Casing removal.

When all casing is removed from a well or boring, the installation of new casing or the reinstallation of casing is considered new construction and must meet all the requirements of this chapter for new construction, including termination of the casing at least 12 inches above the established ground surface, and compliance with the applicable isolation distance requirements.

Subp. 4. [Repealed, 33 SR 211]

Subp. 5. Repair of noncomplying well or boring.

A noncomplying well or boring constructed prior to July 15, 1974, may be repaired as long as the repair meets the requirements of this chapter.

Subp. 6. Casing extension on buried well or boring.

A well or environmental bore hole with the upper termination of the casing buried below the established ground surface must have the casing extended 12 inches above the ground surface when the well or boring is uncovered.

Statutory Authority: MS s 103I.101; 103I.111; 103I.205; 103I.221; 103I.301; 103I.401; 103I.451; 103I.501; 103I.525; 103I.531; 103I.535; 103I.541; 103I.621; 144.05; 144.12; 144.383; 157.04; 157.08; 157.09; 157.13

Disclaimer: These regulations may not be the most recent version. Minnesota may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.