Michigan Administrative Code
Department - Licensing and Regulatory Affairs
Public Service Commission
Michigan Gas Safety Standards
Part 4 - SOUR GAS PIPELINES
Section R. 460.20407 - Sectionalizing block valves

Universal Citation: MI Admin Code R. 460.20407

Current through Vol. 24-16, September 15, 2024

Rule 407. In addition to the requirements in 49 C.F.R. § 192.179, which is adopted by reference in R 460.20606, an operator of pipeline facilities used in the transportation of sour gas shall comply with all of the following requirements for any portion of the pipeline that contains more than 10 pounds of H2S per mile, with the weight calculated according to the formula:

Click Here To View Image

where:

W=Weight of H2S in pounds per mile of pipe,

P=Absolute pressure in pounds per square inch,

V=Volume of one mile of pipe in cubic feet,

M=Molecular weight of the gas in grams per mole,

H= Quantity of H2S in the gas in parts per million,

T=Temperature in degrees Rankine

(a) Sectionalizing block valves must be installed and located so that each point on the pipeline is within 3 miles of a sectionalizing block valve with a block valve located at each end of the pipeline.

(b) A pipeline must incorporate block valve automation so that block valves will automatically close upon the registering of low pressure readings. The system must be designed to operate even in the event of a power failure or malfunction of electronic devices and must be designed to fail in a closed position.

(c) A pipeline must incorporate a supervisory control and data acquisitions (SCADA) system that complies with all of the following provisions:

(i) Is monitored by the operator to ensure appropriate response to emergencies.

(ii) Is programmed to automatically close block valves based on operating data gathered at each metering site and at each automated block valve.

(iii) Automatically closes the upstream and downstream sectionalizing block valves surrounding any sectionalizing block valve that is in an alarm condition.

(iv) Allows the operator monitoring the SCADA system to close, but not open, any or all of the block valves and metering points.

(d) H2S sensors must be located at all sectionalizing block valve sites. The sensors must provide a warning to the SCADA system at H2S levels of 10 ppm and shall close the block valve at H2S levels of 30 ppm.

(e) Control valves must be installed at appropriate locations at well sites or laterals to automatically shut off the flow of gas into the pipeline in the event of a line break or over pressure conditions.

Disclaimer: These regulations may not be the most recent version. Michigan may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.