Michigan Administrative Code
Department - Licensing and Regulatory Affairs
Bureau of Professional Licensing
Board of Architects
Barber
Part 3 - HEALTH, SAFETY, AND SANITATION AT THE PREMISES OF A BARBERSHOP OR BARBER COLLEGE
Section R. 339.6033 - Cleaning, disinfecting, and sterilizing tools and equipment

Universal Citation: MI Admin Code R. 339.6033

Current through Vol. 24-16, September 15, 2024

Rule 33.

(1) Unless otherwise provided under this rule, a licensee, student, or apprentice shall disinfect all non-electrical tools that are not disposed of after each use on a patron in the following sequential manner:

(a) Remove all visible debris.

(b) Wipe sharp-edged tools with a 70% alcohol solution.

(c) Disinfect using 1 of the following methods:
(i) Exposing all surfaces to UV light in compliance with the requirements for disinfection established by the manufacturer of the disinfecting device.

(ii) Fully immersing in a wet sanitizer that contains a sanitizing agent registered with the EPA for not less than 10 minutes or the period recommended by the manufacturer of the disinfectant.

(iii) Scrubbing all surfaces with a disinfectant wipe or clean towel and disinfectant spray that contains a disinfecting agent registered with the EPA.

(d) Fully dry by air or with a clean towel before storing in a clean, covered place such as a fully enclosed drawer, cabinet, or container.

(2) Unless otherwise provided under this rule, a licensee, student, or apprentice shall disinfect all removeable parts of an electrical tool after each use on a patron in the following sequential manner:

(a) Remove all visible debris.

(b) Wipe sharp-edged tools with an alcohol solution of, at a minimum, 70% alcohol.

(c) Disinfect using 1 of the following methods:
(i) Exposing all surfaces to UV light in compliance with the requirements for disinfection established by the manufacturer of the disinfecting device.

(ii) Fully immersing in a wet sanitizer that contains a sanitizing agent registered with the EPA for not less than 10 minutes or the period recommended by the manufacturer of the disinfectant.

(iii) Scrubbing all surfaces with a disinfectant wipe or clean towel and disinfectant spray that contains a disinfecting agent registered with the EPA.

(d) Fully dry by air or with a clean towel before storing in a clean, covered place such as a fully enclosed drawer, cabinet, or container. Electrical items with a cord must not be stored in a container used for storing other clean items.

(3) A licensee, student, or apprentice shall disinfect a shampoo bowl after each use in the following sequential manner:

(a) Remove all visible debris.

(b) Scrub all surfaces with a disinfectant wipe or clean towel and disinfectant spray that contains a disinfecting agent registered with the EPA.

(4) A licensee, student, or apprentice shall dispose of a single-use duster or other brush after each use or disinfect a reusable duster or other brush in the following sequential manner after each use:

(a) Remove all visible debris.

(b) Wash with soap or detergent and water and rinse with clean water.

(c) Immerse in a wet sanitizer for not less than 10 minutes or the period recommended by the manufacturer of the disinfectant.

(5) A licensee, student, or apprentice shall disinfect every barbering chair, headrest, or other station that comes in direct contact with a patron's skin after use by a patron in the following sequential manner:

(a) Remove all visible debris.

(b) Scrub all surfaces with a disinfectant wipe or a clean towel and disinfectant spray that contains a disinfecting agent registered with the EPA.

Disclaimer: These regulations may not be the most recent version. Michigan may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.