Michigan Administrative Code
Department - Licensing and Regulatory Affairs
Bureau of Construction Codes
Elevator Safety Board
Michigan Elevator Rules
Chapter 3 - ASME A17.1 MODIFICATIONS
Section R. 408.7046 - Pressure gauge fittings
Universal Citation: MI Admin Code R. 408.7046
Current through Vol. 24-16, September 15, 2024
Rule 46. Section 3.19.4.5 of the ASME A17.1 code is amended to read as follows:
3.19.4.5 A new hydraulic machine must be provided with the necessary permanent pressure gauge snap-on fittings or permanent gauges, with a shut off valve to allow pressure readings at each pump for checking operating pressures. The gauge or fitting must be located on the jack side of the check valve or immediately adjacent to the hydraulic control valve.
Disclaimer: These regulations may not be the most recent version. Michigan may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
