Michigan Administrative Code
Department - Labor and Economic Opportunity
MIOSHA
General Industry and Construction Safety and Occupational Health Standards
General Industry Safety Standards
Part 23 - HYDRAULIC POWER PRESSES
DESIGN, CONSTRUCTION, AND SETTING OF DIES
Section R. 408.12369 - Die setting
Universal Citation: MI Admin Code R. 408.12369
Current through Vol. 24-16, September 15, 2024
Rule 2369.
(1) A die setting procedure shall be established that will:
(a) Insure that enclosure guards or
protective devices are used and properly installed prior to production,
and
(b) Require the diesetter or
authorized personnel to ascertain that all point of operation safety devices
are effective before releasing the press for operation.
(2) Stops shall be provided to prevent losing control of the die while setting or removing the die on an inclined press.
Disclaimer: These regulations may not be the most recent version. Michigan may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
