Michigan Administrative Code
Department - Labor and Economic Opportunity
MIOSHA
General Industry and Construction Safety and Occupational Health Standards
General Industry Safety Standards
Part 23 - HYDRAULIC POWER PRESSES
DESIGN, CONSTRUCTION, AND SETTING OF DIES
Section R. 408.12367 - Die fastening
Universal Citation: MI Admin Code R. 408.12367
Current through Vol. 24-16, September 15, 2024
Rule 2367.
(1) Provision shall be made in both the upper and lower shoes for securely mounting a die to the bolster and slide. Where clamp caps or setscrews are used in conjunction with punch stems, additional means of securing the upper shoe to the slide shall be used.
(2) A die should be handled with equipment of proper capacity and designed for that purpose.
Disclaimer: These regulations may not be the most recent version. Michigan may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
