Michigan Administrative Code
Department - Labor and Economic Opportunity
MIOSHA
General Industry and Construction Safety and Occupational Health Standards
General Industry Safety Standards
Part 23 - HYDRAULIC POWER PRESSES
DESIGN, CONSTRUCTION, AND SETTING OF DIES
Section R. 408.12366 - Unitized tooling
Universal Citation: MI Admin Code R. 408.12366
Current through Vol. 24-16, September 15, 2024
Rule 2366. When a unitized tooling is used, the opening between the top of the die and face of the slide or striking pad shall be guarded pursuant to the requirements of table 1.
Disclaimer: These regulations may not be the most recent version. Michigan may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
