Michigan Administrative Code
Department - Labor and Economic Opportunity
MIOSHA
General Industry and Construction Safety and Occupational Health Standards
General Industry Safety Standards
Part 1a - ABRASIVE WHEELS
MOUNTING PROVISIONS
Section R. 408.10154 - Mounting nuts
Universal Citation: MI Admin Code R. 408.10154
Current through Vol. 24-16, September 15, 2024
Rule 154.
(1) A single spindle nut shall be tightened only enough to drive the abrasive wheel and prevent slippage.
(2) A multiple screw flange shall be tightened uniformly to distribute pressure over the flange surface and prevent springing of the flange.
Disclaimer: These regulations may not be the most recent version. Michigan may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
