Michigan Administrative Code
Department - Labor and Economic Opportunity
MIOSHA
General Industry and Construction Safety and Occupational Health Standards
General Industry Safety Standards
Part 1a - ABRASIVE WHEELS
MOUNTING PROVISIONS
Section R. 408.10152 - Blotters
Universal Citation: MI Admin Code R. 408.10152
Current through Vol. 24-16, September 15, 2024
Rule 152. A blotter shall be used between a flange and the abrasive wheel. The blotter shall cover the entire contact area of the flange.Exceptions:
(a) Mounted, cone, and plug wheels.
(b) Abrasive discs--inserted nut, inserted washer, and projecting stud type.
(c) Plate mounted wheels.
(d) Cylinders, cups, or segmented wheels that are chuck mounted.
(e) Type 27 and 28 depressed center wheels.
(f) Cutting-off wheels.
(g) Internal wheels not more than 2 inches in diameter.
(h) Type 4 tapered wheels.
(i) Diamond and Borzon type wheels.
(j) Terrazzo wheels.
(k) Type 27A cutting-off wheels.
Disclaimer: These regulations may not be the most recent version. Michigan may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
