Michigan Administrative Code
Department - Labor and Economic Opportunity
MIOSHA
General Industry and Construction Safety and Occupational Health Standards
General Industry Safety Standards
Part 1a - ABRASIVE WHEELS
GUARDING PROVISIONS
Section R. 408.10121 - General requirements

Universal Citation: MI Admin Code R. 408.10121

Current through Vol. 24-16, September 15, 2024

Rule 121.

(1) An abrasive wheel shall be provided with a guard, except as noted in this subrule, which shall cover the spindle end, nut, and flange projections, as well as the periphery, other than where work is to be performed (see figures). Exceptions are as follows:

(a) Wheels used for internal grinding while advancing or retracting the work or while within the work.

(b) Mounted wheels that are not more than 2 inches in diameter.

(c) Plug and cones that are not more than 3 inches in diameter or 5 inches in length.

(d) A type l reinforced wheel which is not more than 3 inches in diameter and 1/4 inch thick and with which safety glasses and face shield protection are provided and used as prescribed in Part 33. Personal Protective Equipment, being R 408.13301 et seq. of the Michigan Administrative Code.

(e) Lapidary grinding. A metal diamond lapidary blade which is notched, segmented, or continuous rim and which is used within a coolant deflector does not require guards for speeds of not more than 3,500 sfpm.

(f) Tuck point wheel, masonry, or concrete saws may have the spindle end, nut, and flange exposed as per figures 1 and 2 of R 408.10198.

(2) The guard shall be constructed of material that is capable of retaining pieces of a broken wheel. See material tables. The guard shall be mounted so as to maintain alignment with the abrasive wheel to contain wheel breakage, and the strength of the fastenings shall exceed the strength of the guard. The guard shall be in position before starting the wheel.

(3) Where flying particles or fragments are a hazard to employees other than the grinder operator, an enclosure or barrier shall be provided to isolate the operation from the remaining working area.

(4) When openings in the wheel safety guard assemblies are required for dressing, a means shall be provided to protect the operator and other personnel from the hazards of flying particles, sparks, or wheel fragments.

Disclaimer: These regulations may not be the most recent version. Michigan may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.