Michigan Administrative Code
Department - Labor and Economic Opportunity
MIOSHA
General Industry and Construction Safety and Occupational Health Standards
General Industry Safety Standards
Part 14 - CONVEYORS
SPECIFIC CONVEYORS
Section R. 408.11450 - Roller conveyors

Universal Citation: MI Admin Code R. 408.11450

Current through Vol. 24-16, September 15, 2024

Rule 1450.

(1) A roller conveyor with a hinged section or with an open discharge end shall be equipped with a stop device projecting above the rollers which shall prevent a package or object from being discharged off the conveyor unless it is so designed to discharge.

(2) Nip points between power and idler rolls or delivery conveyors and idler rolls shall be eliminated by 1 of the following:

(a) The idler roller set in a 45 degree inclined slot in the direction of travel.

(b) Steel plates welded between the rolls with a maximum of 1/8 inch between plate and rolls.

(c) The idler roller set in a horizontal slot and connected with an interlock switch which will stop the conveyor.

(d) A device which offers equal or better protection may be substituted for subdivision (a), (b), or (c) of this subrule.

(3) The nip point between a belt and a carrier roller on a belt drive live roller conveyor shall be protected by pop-out type carrier rollers or steel plates as prescribed in subrule (2)(a) and (b) of this rule. The belt conveyor shall be guarded as specified in R 408.11442.

Disclaimer: These regulations may not be the most recent version. Michigan may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.