Michigan Administrative Code
Department - Labor and Economic Opportunity
MIOSHA
General Industry and Construction Safety and Occupational Health Standards
General Industry Safety Standards
Part 11 - POLISHING, BUFFING & ABRADING
Section R. 408.11118 - Flanges
Universal Citation: MI Admin Code R. 408.11118
Current through Vol. 24-16, September 15, 2024
Rule 1118.
(1) A flange shall be used with a metal or fibre center bias buff, except where the flange is an integral part of the buff.
(2) A flange shall:
(a) Be 3/16 inch thick for buff face up to 6
inches wide and 3/8 inch thick for a wider buff face.
(b) Be of a diameter to bear firmly on the
clinch ring.
(c) Be of the same
diameter and design of both sides.
(d) Be made of steel or material of equal
strength.
(3) A flange should be tapered or bell shape instead of flat. See figure 3.
Disclaimer: These regulations may not be the most recent version. Michigan may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
