Michigan Administrative Code
Department - Environmental Quality
Air Quality Division
Part 2 - AIR USE APPROVAL
Section R. 336.1287 - Permit to install exemptions; surface coating equipment
Universal Citation: MI Admin Code R. 336.1287
Current through Vol. 24-04, March 15, 2024
Rule 287.
(1) This rule does not apply if prohibited by R 336.1278 and unless the requirements of R 336.1278a have been met.
(2) The requirement of R 336.1201(1) to obtain a permit to install does not apply to any of the following:
(a) An adhesive coating line which has an
application rate of less than 2 gallons per day and which has emissions that
are released only into the general in-plant environment.
(b) A surface coating process that uses only
hand-held aerosol spray cans, including the puncturing and disposing of the
spray cans, or other coatings that are manually applied from containers not to
exceed 8 ounces in size.
(c) A
surface coating line if all of the following conditions are met:
(i) The coating use rate is not more than 200
gallons, as applied, minus water, per month.
(ii) Any exhaust system that serves only
coating spray equipment is supplied with a dry filter control or water wash
control which is installed, maintained, and operated in accordance with the
manufacturers specifications, or the owner or operator develops a plan which
provides to the extent practicable for the maintenance and operation of the
equipment in a manner consistent with good air pollution control practices for
minimizing emissions.
(iii) Monthly
coating use records are maintained on file for the most recent 2-year period
and are made available to the department upon request.
(d) A powder coating booth and associated
ovens, where the booth is equipped with fabric filter control. The fabric
filter control shall be installed, maintained, and operated in accordance with
the manufacturers specifications or the owner or operator shall develop a plan
that provides to the extent practicable for the maintenance and operation of
the equipment in a manner consistent with good air pollution control practices
for minimizing emissions.
(e) A
silkscreen process.
(f) Replacement
of waterwash control in a paint spray booth with dry filter control.
(g) Adding dry filters to paint spray
booths.
(h) Replacement of a
coating applicator system with a coating applicator system that has an
equivalent or higher design transfer efficiency, unless the change is
specifically prohibited by a permit condition.
(i) Equipment that is used for the
application of a hot melt adhesive.
(j) Portable equipment that is used for
on-site nonproduction painting.
(k)
Mixing, blending, or metering operations associated with a surface coating
line.
Disclaimer: These regulations may not be the most recent version. Michigan may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
