Michigan Administrative Code
Department - Environmental Quality
Air Quality Division
Part 2 - AIR USE APPROVAL
Section R. 336.1205 - Permit to install; approval
Current through Vol. 24-04, March 15, 2024
Rule 205.
(1) The department shall not approve a permit to install for a stationary source, process, or process equipment that meets the definition of a major stationary source or major modification under any part of these rules unless the requirements specified in subdivisions (a) and (b) of this subrule have been met. In addition, except as provided in subrule (3) of this rule, the department shall not approve a permit to install that includes limitations which restrict the potential to emit from a stationary source, process, or process equipment to a quantity below that which would constitute a major source or major modification under any part of these rules unless both of the following requirements have been met:
(2) The department shall not approve a permit to install to construct a major source or reconstruct a major source under any applicable requirement of section 112 of the clean air act unless the requirements of subrule (1)(a) and (b) of this rule have been met. In addition, except as provided in subrule (3) of this rule, the department shall not approve a permit to install that includes limitations which restrict the potential to emit of a stationary source, process, or process equipment to a quantity below that which would constitute a major source or modification under any applicable requirement of section 112 of the clean air act unless the requirements of subrule (1)(a) and (b) of this rule have been met.
(3) The department may approve a permit to install that includes limitations that restrict the potential to emit of a stationary source, process, or process equipment to a quantity below that which would constitute a major source or major modification under any part of these rules without meeting the requirement of subrule (1)(b) of this rule if the emission limitations restrict the potential to emit of the stationary source, process, or process equipment to less than 90% of the quantity referenced in the applicable requirement.