(A)
Protection Surveys.
(1) The registrant shall ensure that
radiation protection surveys of all new facilities, and existing facilities not
previously surveyed, are performed with an operable radiation measurement
survey instrument calibrated in accordance with
105 CMR
120.438. The radiation protection survey
shall be performed by, or under the direction of, a Qualified Medical Physicist
or a Certified Health Physicist and shall verify that, with the therapeutic
radiation machine in a "BEAM-ON" condition, with the largest clinically
available treatment field and with a scattering phantom in the useful beam of
radiation. The following standards must be met and recorded:
(a) Radiation levels in restricted areas are
not likely to cause personnel exposures in excess of the limits specified in
105 CMR
120.211(A); and,
(b) Radiation levels in unrestricted areas do
not exceed the limits specified in
105 CMR
120.221(A) and
(B).
(2) In addition to the requirements of 105
CMR 120.434(A)(1), a radiation protection survey shall also be performed prior
to any subsequent medical use and:
(a) After
making any structural or composite modifications to the treatment room
shielding;
(b) After making any
changes in the location of the therapeutic radiation machine within the
treatment room;
(c) After
relocating the therapeutic radiation machine; or
(d) Before using the therapeutic radiation
machine in a manner that could result in increased radiation levels in areas
outside the external beam radiation therapy treatment room.
(3) The survey record shall
indicate all instances where the facility, in the opinion of the Qualified
Medical Physicist or a Certified Health Physicist, is in violation of
applicable regulations. The survey record shall also include the date of the
measurements, the reason the survey is required, the manufacturer's name, model
number and serial number of the therapeutic radiation machine, the
instrument(s) used to measure radiation levels, a plan of the areas surrounding
the treatment room that were surveyed, the measured dose rate at several points
in each area expressed in microsieverts or millirems per hour, the calculated
maximum level of radiation over a period of one week for each restricted and
unrestricted area, and the signature of the individual responsible for
conducting the survey;
(4) If the
results of the surveys required by 105 CMR 120.434(A)(1) or (2) indicate any
radiation levels in excess of the respective limit specified in 105 CMR
120.434(A)(1), the registrant shall lock the control in the "OFF" position and
not use the unit:
(a) Except as may be
necessary to repair, replace, or test the therapeutic radiation machine, the
therapeutic radiation machine shielding, or the treatment room shielding;
or
(b) Until the registrant has
received a specific exemption from the Agency.
(B)
Modification of Radiation
Therapy Unit or Room Before Beginning a Treatment Program. If the
survey required by 105 CMR 120.434(A) indicates that an individual in an
unrestricted area may be exposed to levels of radiation greater than those
permitted by
105 CMR
120.221(A) and (B), before
beginning the treatment program the registrant shall:
(1) Either equip the unit with beam direction
interlocks or add additional radiation shielding to ensure compliance with
105 CMR
120.221(A) and
(B);
(2) Perform the survey required by 105 CMR
120.434(A) again; and,
(3) Include
in the report required by 105 CMR 120.434(D) the results of the initial survey,
a description of the modification made to comply with 105 CMR 120.434(B)(1),
and the results of the second survey; or,
(4) Request and receive a registration
amendment under
105 CMR
120.221(C). that authorizes
radiation levels in unrestricted areas greater than those permitted by
105 CMR
120.221(A) and
(B).
(C)
Dosimetry
Equipment.
(1) The registrant
shall have a calibrated dosimetry system available for use. The system shall
have been calibrated by the National Institute for Standards and Technology
(NIST) or by an American Association of Physicists in Medicine (AAPM)
Accredited Dosimetry Calibration Laboratory (ADCL). The calibration shall have
been performed within the previous 24 months and after any servicing that may
have affected system calibration.
(a) For
beams with energies greater than one MV (one MeV), the dosimetry system shall
have been calibrated for Cobalt-60;
(b) For beams with energies equal to or less
than one MV (one MeV), the dosimetry system shall have been calibrated at an
energy (energy range) appropriate for the radiation being measured;
(2) The registrant shall have
available for use a dosimetry system for quality assurance check measurements.
To meet this requirement, the system may be compared with a system that has
been calibrated in accordance with 105 CMR 120.434(C)(1) This comparison shall
have been performed within the previous 12 months and after each servicing that
may have affected system calibration. The quality assurance check system may be
the same system used to meet the requirement in 105 CMR
120.434(C)(1);
(3) The registrant
shall maintain a record of each dosimetry system calibration, intercomparison,
and comparison for the duration of the license and/or registration. For each
calibration, intercomparison, or comparison, the record shall include the date,
the model numbers and serial numbers of the instruments that were calibrated,
inter-compared, or compared as required by 105 CMR 120.434(C)(1) and (2), the
correction factors that were determined, the names of the individuals who
performed the calibration, intercomparison, or comparison, and evidence that
the intercomparison was performed by, or under the direct supervision and in
the physical presence of, a Qualified Medical Physicist.
(D)
Reports of External Beam
Radiation Therapy Surveys and Measurements. The registrant for any
therapeutic radiation machine subject to
105 CMR
120.436 or
120.437
shall furnish a copy of the records required in 105 CMR 120.434(A) and (B) to
the Agency within 30 days following completion of the action that initiated the
record requirement.