Louisiana Administrative Code
Title 33 - ENVIRONMENTAL QUALITY
Part III - Air
Chapter 15 - Emission Standards for Sulfur Dioxide
Section III-1503 - Emission Limitations and Compliance

Universal Citation: LA Admin Code III-1503

Current through Register Vol. 50, No. 9, September 20, 2024

A. Sulfuric Acid Plants-New and Existing. The emissions of sulfur dioxide and acid mist from new sulfuric acid production units that commence construction or modification after August 17, 1971, shall be limited to that specified in 40CFR 60.82 and 60.83, as incorporated by reference in LAC33:III.Chapter 30, i.e., 4.0 pounds of SO2/ton of 100 percent H2SO4 (2 kilograms/metric ton) and 0.15 pounds of sulfuric acid mist/ton of 100percent H2SO4 (.075 kilograms/metric ton), respectively (three-hour averages). Emissions from existing units shall be limited as follows:

1. SO2- not more than 2000 ppm by volume (three-hour average);

2. sulfuric acid mist- not more than 0.5pounds/ton of 100 percent H2SO4 (0.25 kilograms/metric ton) (three-hour average).

B. Sulfur Recovery Plants-New and Existing. The emission of sulfur oxides calculated as sulfur dioxide from a new sulfur recovery plant that commences construction or modification after October 4, 1976, shall be limited to that specified in 40 CFR 60.104(a)(2), as incorporated by reference in LAC 33:III.Chapter 30. The emission of sulfur oxides calculated as sulfur dioxide from an existing plant shall be limited to a sulfur dioxide concentration of not more than 1,300 ppm by volume (three-hour average).

C. All Other Sources-New and Existing. No person shall discharge gases from the subject sources that contain concentrations of SO2 in excess of 2,000 parts per million (ppm) by volume at standard conditions (three-hour average), or any applicable Federal NSPS or NESHAP emission limitation, whichever is more stringent. Single point sources that emit or have the potential to emit less than 250 tons per year of sulfur compounds measured as sulfur dioxide may be exempted from the 2,000 ppm(v) limitation by the administrative authority.

D. Compliance

1. The methods listed in Table 4 or any such equivalent method as may be approved by the administrative authority* shall be used to determine compliance with the appropriate emission limitations set forth in Subsections A-C of this Section. These methods shall be used for the following:
a. initial compliance determinations; and

b. any additional compliance determinations as requested by the administrative authority.

2. Measurement equipment shall be periodically calibrated to comply with minimal American Bureau of Standards criteria.

3. The data collected from a sulfur dioxide continuous emission monitoring system (CEMS) may be used to determine initial compliance with the sulfur dioxide emission limitations of this Section.

4. As used in this Section a three-hour average means the average emissions for any three consecutive one-hour periods (each commencing on the hour), provided that the number of three-hour periods during which the SO2 limitation is exceeded is not greater than the number of one-hour periods during which the SO2 limitation is exceeded.

Table 4

Emissions-Methods of Contaminant Measurement

Emission

Analytical Method

Particulate

1. Methods 1, 2, 3, 4, 5 ( 40 CFR Part 60, Appendix A, as incorporated by reference at LAC 33:III.3003) or §60.8 of 40 CFR Part 60 as incorporated by reference at LAC 33:III.3003.

Sulfur Oxides

1. Seidman, Analytical Chemistry Volume 30, page 1680 (1958), "Determination of Sulfur Oxides in Stack Gases."

2. Shell Development Company method for the Determination of Sulfur Dioxide and Sulfur Trioxide PHS 999 AP-13 Appendix B, pages 85-87, "Atmospheric Emissions Sulfuric Acid Manufacturing Processes."

3. Reich Test for Sulfur Dioxide, "Atmospheric Emissions from Sulfuric Acid Manufacturing Process" PHS 999 AP-13 Appendix B, pages 76-80.

4. The Modified Monsanto Company Method, "Atmospheric Emissions from Sulfuric Acid Manufacturing Process" PHS 999 AP-13, Appendix B, pages 61-67.

5. Test Methods 1, 2, 3, 4, 6C, and 8 (40 CFR Part 60, Appendix A, as incorporated by reference at LAC 33:III.3003), or §60.8 of 40 CFR Part 60 as incorporated by reference at LAC 33:III.3003.

Oxides of Nitrogen

1. Test Methods 1, 2, 3, 4, and 7E (40 CFR Part 60, Appendix A, as incorporated by reference at LAC 33:III.3003), or §60.8 of 40 CFR Part 60 as incorporated by reference at LAC 33:III.3003.

Visible Emissions

1. Method 9 (40 CFR Part 60, Appendix A, as incorporated by reference at LAC 33:III.3003).

2. Method 22 (40 CFR Part 60, Appendix A, as incorporated by reference at LAC 33:III.3003).

Total Fluoride

1. Methods 1, 2, 3, 13A and 13B (40 CFR Part 60, Appendix A, as incorporated by reference at LAC 33:III.3003).

Total Reduced Sulfur (TRS)

1. Method 16 (40 CFR Part 60, Appendix A or §60.8 of 40 CFR Part 60 as incorporated by reference at LAC 33:III.3003).

2. Coulometric titration by method specified in NCASI Atmospheric Quality Improvement Technical Bulletin Number 91 (January 1978).

Sulfuric Acid Mist

1. Test methods 1, 2, 3, 4, 6, and 8 (40 CFR Part 60, Appendix A or §60.8 of 40 CFR Part 60 as incorporated by reference at LAC 33:III.3003).

AUTHORITY NOTE: Promulgated in accordance with R.S. 30:2054.

Disclaimer: These regulations may not be the most recent version. Louisiana may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.