Kansas Administrative Regulations
Agency 99 - KANSAS STATE DEPARTMENT OF AGRICULTURE DIVISION OF WEIGHTS AND MEASURES
Article 31 - MOTOR-VEHICLE FUEL MEASURING DEVICES
Section 99-31-5 - Removal of rejection tags
Current through Register Vol. 43, No. 39, September 26, 2024
(a) For the purpose of testing or repairing a dispensing device, any licensed testing service company may remove an official rejection tag or other mark placed on a dispensing device by authority of the secretary.
(b) After the test is conducted and necessary repairs are completed, the testing service company shall place the dispensing device in service until examination by the secretary. If the dispensing device is not repaired properly, the testing service company shall replace the rejection tag or other mark with a substitute rejection tag or other mark supplied by the secretary.
(c) After removing an official rejection tag for the purpose of repairing a device, the service company shall send a completed inspection or test report and the official rejection tag to the weights and measures office within 10 days from the date of removing the official rejection tag. The completed inspection or test report may be submitted by means of facsimile. The inspection or test report or other attached document shall detail all repairs made, and the testing shall be conducted to ensure that the device is in compliance with Kansas law and K.A.R. 99-25-1.
(d) Any licensed testing service company may file notifications or reports required by this regulation by means of facsimile. Notifications or reports mailed to the administrator shall be considered timely if they are postmarked on or before the 10th day following the calibration, repair, or adjustment described in the notification or report.
(e) This regulation shall apply to new and used dispensing devices.
