Kansas Administrative Regulations
Agency 49 - DEPARTMENT OF LABOR
Article 52 - LOW PRESSURE HEATING BOILERS
Section 49-52-14 - Repairs and renewals of fittings and appliances
Universal Citation: KS Admin Regs 49-52-14
Current through Register Vol. 43, No. 12, March 20, 2024
(a) If repairs are made to fittings or appliances or if it becomes necessary to replace them, the repairs shall meet the following standards:
(1) Sections I, IV, and VIII of the ASME code
for new construction, as adopted in K.A.R. 49-45-1, K.A.R. 49-45-5, K.A.R.
49-45-29, K.A.R. 49-45-30, and K.A.R. 49-45-31;
(2) ASME CSD-1, as adopted in K.A.R.
49-45-27;
(3) NFPA 85, 85A, 85F,
and 86, as adopted in K.A.R. 49-45-37 through K.A.R. 49-45-40; and
(4) the national board inspection code, as
adopted in K.A.R. 49-45-20.
(b) Each electrical control and each safety device shall bear a label and shall be listed by a nationally recognized agency, including UL (underwriters laboratories), FM (factory mutual), or AGA (American gas association), and shall bear an identification label from one of these agencies.
Disclaimer: These regulations may not be the most recent version. Kansas may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
