Kansas Administrative Regulations
Agency 4 - DEPARTMENT OF AGRICULTURE
Article 10 - ANHYDROUS AMMONIA
Section 4-10-4e - Hose specifications
Universal Citation: KS Admin Regs 4-10-4e
Current through Register Vol. 43, No. 52, December 26, 2024
(a) Each hose with a diameter of at least 1/2 inch used in ammonia service and subject to container pressure shall withstand at least 350 psig and shall have the following information etched, cast, or impressed in a legible format at intervals not to exceed five feet along the hose surface:
(1) The phrase "Anhydrous Ammonia";
(2) the maximum working pressure of the hose;
and
(3) the date the hose is to be
removed from service.
(b) Each hose shall meet or exceed ASME schedule 80 specifications and have factory-installed ends designed for use with anhydrous ammonia.
(c) Each hose shall be replaced before or upon the expiration of the manufacturer's removal date.
(d) A hose shall be removed from service if a visual examination reveals any of the following:
(1) Illegibility of any of the markings
required in subsection (a);
(2)
cuts exposing reinforcing fabric;
(3) soft spots or bulges in the
hose;
(4) a blistering or loose
outer covering;
(5) kinking or
flattening;
(6) stretch
marks;
(7) slippage at any
coupling; or
(8) any other damage
that could compromise the integrity of the safe use of the hose.
Disclaimer: These regulations may not be the most recent version. Kansas may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.