Kansas Administrative Regulations
Agency 36 - KANSAS DEPARTMENT OF TRANSPORTATION
Article 7 - STUD TIRES
Section 36-7-2 - Use of studded traction equipment permitted; definitions; limitations on use

Universal Citation: KS Admin Regs 36-7-2

Current through Register Vol. 43, No. 12, March 20, 2024

(a) Definitions.

(1) "Vehicles" shall have the meaning set forth at K.S.A. 8-1485.

(2) "Highway" shall have the meaning set forth at K.S.A. 8-1424.

(3) "Studded traction equipment" means any device designed to be attached or placed on an automobile tire or small truck tire for the purpose of increasing traction in snow, ice or other conditions tending to cause a vehicle to skid. For purposes of this regulation "truck" shall mean a vehicle registered with the Kansas department of revenue of a gross vehicle weight of 12,000 lbs. or less. Depending on the design and application, the device may cover all of the tire tread or a portion of the tire tread at frequent intervals from the perimeter of the tire.

(b) Stud-type protrusions consisting of tungsten carbide or other material of similar substances that will not sliver or shatter upon striking concrete or other hard material may extend outward from the periphery of the studded traction device. When installed the tungsten tip of the stud shall project not less than .040 inch nor more than .090 inch above the surface. The device to which the studs or protrusions are attached shall extend across the tread of the tire at intervals of not less than twelve inches when measured along the circumference of the tire. Studs shall be securely attached to the device in such manner that they will not become dislodged from the device by striking some object or from centrifugal force.

(c) The number of studs per device shall be controlled by the size of tire and shall be a minimum of 32 studs.

(d) Studded traction equipment shall be permissible for use on highways within this state on and after November 1 of each year to and including April 1 of the succeeding year.

(e) The manufacturer of studded traction equipment shall be responsible for the proper installation of studs when inserted at the factory and when inserted by dealers who operate factory-owned stores.

(f) A manufacturer of studded traction equipment seeking prior approval of such equipment for legal sale or use in Kansas shall make written application to the secretary of the Kansas department of transportation. The application shall state that the device meets all of the requirements for studded traction equipment as specified in this regulation. The secretary reserves the right to require additional proof of equipment or stud conformity. The additional requirements may include submission to the secretary of one or more pairs of studded traction equipment for which approval is requested.

(g) The secretary of the Kansas department of transportation reserves the right to deny a certificate of approval for studded traction equipment that does not meet the standards and specifications of this regulation.

Disclaimer: These regulations may not be the most recent version. Kansas may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.