Indiana Administrative Code
Title 865 - STATE BOARD OF REGISTRATION FOR PROFESSIONAL SURVEYORS
Article 1 - GENERAL PROVISIONS
Rule 7 - Registrant's Seal
Section 7-1 - Design and contents of seal
Universal Citation: 865 IN Admin Code 7-1
Current through September 18, 2024
Authority: IC 25-21.5-2-14
Affected: IC 25-21.5
Sec. 1.
(a) The land surveyor seal shall be not less than one and five-eighths (1e) inches or more than one and seven-eighths (1 7/8) inches in outside diameter, using the following
(b) The seal may:
(1) be:
(A)
embossed;
(B) stamped; or
(C) electronically applied;
in conformance with the design as shown in subsection (a); and
(2) have:
(A) a milled edge, as shown in subsection
(a); or
(B) two (2) concentric
circles with the outer and inner circles corresponding with the respective
edges of the milling.
(c) The name and registration number of the registrant inscribed on the seal shall correspond to the name and certificate number inscribed on the certificate of registration.
864 IAC 1.1-7-2 was renumbered by Legislative Services Agency as 865 IAC 1-7-1.
Disclaimer: These regulations may not be the most recent version. Indiana may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
