Indiana Administrative Code
Title 675 - FIRE PREVENTION AND BUILDING SAFETY COMMISSION
Article 15 - INDUSTRIALIZED BUILDING SYSTEMS
Rule 2 - Indiana Mobile Structures Code
- Section 2-1 - Title, classification, availability, and applicability of rule
- Section 2-2 - Definitions
- Section 2-3 - Source of design and construction standards
- Section 2-4 - Scope of design and construction standards
- Section 2-5 - Basic principles of design and construction
- Section 2-6 - Definitions for design and construction
- Section 2-7 - General design and construction requirements
- Section 2-8 - Design dead loads
- Section 2-9 - Design live loads
- Section 2-10 - Wind, roof, and snow loads
- Section 2-11 - Fastening of structural systems
- Section 2-12 - Walls
- Section 2-13 - Floors
- Section 2-14 - Design load deflection
- Section 2-15 - Structural load tests
- Section 2-16 - Weather resistance
- Section 2-17 - Condensation resistance for residential systems
- Section 2-18 - Interior walls, partitions, and ceilings
- Section 2-19 - Rodent resistance
- Section 2-20 - Heat loss; mobile system
- Section 2-21 - Design considerations
- Section 2-22 - Ceiling height
- Section 2-23 - Exits
- Section 2-24 - Room and hallway sizes
- Section 2-25 - Glass and glazed openings
- Section 2-26 - Smoke detectors
- Section 2-27 - Smoke detector locations
- Section 2-28 - Alarm sounding devices
- Section 2-29 - Detector trouble signals
- Section 2-30 - Testing detectors
- Section 2-31 - In-transit design requirements
- Section 2-32 - Scope of plumbing standards
- Section 2-33 - Basic principles of plumbing standards
- Section 2-34 - Definitions for plumbing standards
- Section 2-35 - General plumbing requirements
- Section 2-36 - Protection of plumbing system
- Section 2-37 - Material standards
- Section 2-38 - Joints and connections
- Section 2-39 - Traps
- Section 2-40 - Cleanouts
- Section 2-41 - Fixtures and connections
- Section 2-42 - Toilets; shower compartments; dishwashers; washing machines
- Section 2-43 - Installation of fixtures
- Section 2-44 - Piping strains and stresses
- Section 2-45 - Piping supports
- Section 2-46 - Hangers and anchors
- Section 2-47 - Water supply piping; hot water supply system
- Section 2-48 - Water connections and outlets
- Section 2-49 - Water heaters; relief valves; prohibited location
- Section 2-50 - Material standards for water piping and fittings
- Section 2-51 - Installation of piping
- Section 2-52 - Size of water supply piping
- Section 2-53 - Drainage systems; materials
- Section 2-54 - Drain outlets
- Section 2-55 - Drain connections
- Section 2-56 - Size of drainage piping
- Section 2-57 - Wet-vented drainage system
- Section 2-58 - Offsets and branch fittings
- Section 2-59 - Grade of horizontal drainage piping
- Section 2-60 - Vent piping and fittings
- Section 2-61 - Material standards for vent piping and fittings
- Section 2-62 - Size of vent piping
- Section 2-63 - Anti-siphon trap vent
- Section 2-64 - Horizontal vent connections and grade
- Section 2-65 - Vent terminal
- Section 2-66 - Vent caps
- Section 2-67 - Water pressure tests
- Section 2-68 - Waste and vent system tests
- Section 2-69 - Fixture tests
- Section 2-70 - Shower compartment tests
- Section 2-71 - Scope of heating, cooling, and fuel-burning system standards
- Section 2-72 - Definitions for heating, cooling, and fuel-burning systems
- Section 2-73 - LP-gas systems; service line pressure
- Section 2-74 - LP-gas containers
- Section 2-75 - Oil tanks
- Section 2-76 - Gas piping systems
- Section 2-77 - Oil piping systems
- Section 2-78 - General appliance standards
- Section 2-79 - Gas clothes dryers
- Section 2-80 - Installation of appliances
- Section 2-81 - Venting and combustion air systems
- Section 2-82 - Operating instructions
- Section 2-83 - Appliance information
- Section 2-84 - Access to appliances
- Section 2-85 - Location of appliances
- Section 2-86 - Clearances
- Section 2-87 - Circulating air system
- Section 2-88 - Scope of electrical standards
- Section 2-89 - Definitions for electrical standards
- Section 2-90 - Power supply
- Section 2-91 - Disconnecting means and branch-circuit protective equipment
- Section 2-92 - Receptacle outlets
- Section 2-93 - Fixtures; appliances
- Section 2-94 - Wiring methods and materials
- Section 2-95 - Grounding
- Section 2-96 - Insulated neutral
- Section 2-97 - Equipment grounding
- Section 2-98 - Bonding of noncurrent-carrying metal parts
- Section 2-99 - Electrical tests
- Section 2-100 - Load calculations
- Section 2-101 - Interconnection of multiple section mobile residential structures
- Section 2-102 - Outdoor fixtures, outlets, and appliances
- Section 2-103 - Painting of wiring
- Section 2-104 - Polarization
Disclaimer: These regulations may not be the most recent version. Indiana may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
