Indiana Administrative Code
Title 329 - SOLID WASTE MANAGEMENT DIVISION
Article 4.1 - REGULATION OF WASTES CONTAINING PCBS
Rule 13 - Disposal of Wastes Containing or Contaminated with PCBs in Solid Waste Land Disposal Facilities Regulated under 329 IAC 10
Section 13-3 - Disposal of waste containing PCBs; state authorization
Current through September 18, 2024
Authority: IC 13-20-15-1
Affected: IC 13-20-15-6
Sec. 3.
(a) This section does not apply to the disposal of PCB household waste, as defined at 40 CFR 761.3.
(b) If the requirements of section 1 of this rule do not include a requirement for approval by the U.S. EPA Regional Administrator before disposal of a PCB waste, then in addition to compliance with the requirements of section 1 of this rule, a person who disposes of any waste containing PCBs in a MSWLF unit that does not meet the design requirements of 329 IAC 10-17 or in a nonmunicipal solid waste landfill that is not specifically permitted to accept the waste shall do the following:
(c) If the requirements of section 1 of this rule do not include a requirement for approval by the U.S. EPA Regional Administrator before disposal of a PCB waste, then in addition to compliance with the requirements of section 1 of this rule, a person who disposes of a waste listed in Table 1 in a MSWLF unit that meets the design requirements of 329 IAC 10-17, or in a nonmunicipal solid waste landfill permitted to accept the PCB waste, shall do the following:
Table 1.
Waste that contains PCBs at a concentration less than fifty (50) ppm PCBs, resulting from a source that had a PCB concentration greater than or equal to fifty (50) ppm PCBs.
Items or wastes containing inadvertently generated PCBs.
