(b) Owners and operators of used oil
processors and re-refiners facilities must comply with the following
requirements:
(1) Each owner or operator must
have a contingency plan for the facility. The contingency plan must be:
(A) designed to minimize hazards to human
health and the environment from fires, explosions, or any unplanned sudden or
nonsudden release of used oil to air, soil, or surface water; and
(B) carried out immediately whenever there is
a fire, explosion, or release of used oil that could threaten human health or
the environment.
(2) The
contingency plan must contain the following:
(A) A description of the actions facility
personnel must take to comply with this subsection in response to fires,
explosions, or any unplanned sudden or nonsudden release of used oil to air,
soil, or surface water at the facility.
(B) A description of the arrangements agreed
to by local police departments, fire departments, hospitals, contractors, and
state and local emergency response teams to coordinate emergency services under
subsection (a)(6).
(C) An
up-to-date list of names, addresses, and office and home phone numbers of all
persons qualified to act as emergency coordinator as described in subdivision
(6). Where more than one (1) person is listed, one (1) must be named as primary
emergency coordinator and others must be listed in the order in which they will
assume responsibility as alternates.
(D) An up-to-date list of all emergency
equipment at the facility, such as fire extinguishing systems, spill control
equipment, communications and internal and external alarm systems, and
decontamination equipment, where this equipment is required. In addition, the
plan must include the location and a physical description of each item on the
list and a brief outline of its capabilities.
(E) An evacuation plan for facility personnel
where there is a possibility that evacuation could be necessary. This plan must
describe the signal or signals to be used to begin evacuation, evacuation
routes, and alternate evacuation routes in cases where the primary routes could
be blocked by releases of used oil or fires.
(3) If the owner or operator has already
prepared a spill prevention, control, and countermeasures (SPCC) plan in
accordance with 40 CFR 112, or some other emergency or contingency plan, the
owner or operator need only amend that plan to incorporate used oil management
provisions that are sufficient to comply with the requirements of this
article.
(4) A copy of the
contingency plan and all revisions to the plan must be:
(A) maintained at the facility; and
(B) submitted to all local police
departments, fire departments, hospitals, and state and local emergency
response teams that may be called upon to provide emergency services.
(5) The contingency plan must be
reviewed, immediately amended, and redistributed to the entities identified in
subdivision (4)(B), if necessary, whenever:
(A) applicable regulations are
revised;
(B) the plan fails in an
emergency;
(C) the facility changes
in its design, construction, operation, maintenance, or other circumstances:
(i) in a way that materially increases the
potential for fires, explosions, or releases of used oil; or
(ii) changes the response necessary in an
emergency;
(D) the list
of emergency coordinators changes; or
(E) the list of emergency equipment
changes.
(6) At all
times, there must be at least one (1) employee either on the facility premises
or on call, who is available to respond to an emergency by reaching the
facility within a short period of time, with the responsibility for
coordinating all emergency response measures. This emergency coordinator must
be thoroughly familiar with:
(A) all aspects
of the facility's contingency plan;
(B) all operations and activities at the
facility;
(C) the location and
characteristics of used oil handled;
(D) the location of all records within the
facility; and
(E) the facility
layout.
In addition, this person must have the authority to commit
the resources needed to carry out the contingency plan. The emergency
coordinator's responsibilities include those listed in subdivision (7).
Applicable responsibilities for the emergency coordinator vary, depending on
factors, such as type and variety of used oil handled by the facility, and type
and complexity of the facility.
(7) Emergency procedures must be handled as
follows:
(A) Whenever there is an imminent or
actual emergency situation, the emergency coordinator, or the designee when the
emergency coordinator is on call, must immediately:
(i) activate internal facility alarms or
communication systems, where applicable, to notify all facility personnel;
and
(ii) notify appropriate state
or local agencies with designated response roles if their help is
needed.
(B) Whenever
there is a release, fire, or explosion, the emergency coordinator must
immediately identify the character, exact source, amount, and a real extent of
any released materials. This may be accomplished by observation or review of
facility records of manifests and, if necessary, by chemical
analysts.
(C) Concurrently, the
emergency coordinator must assess possible hazards to human health or the
environment that may result from the release, fire, or explosion. This
assessment must consider both direct and indirect effects of the release, fire,
or explosion, such as:
(i) the effects of any
toxic, irritating, or asphyxiating gases that are generated; or
(ii) the effects of any hazardous surface
water run-offs from water of chemical agents used to control fire and
heat-induced explosions.
(D) If the emergency coordinator determines
that the facility has had a release, fire, or explosion that could threaten
human health or the environment outside the facility, the emergency coordinator
must report any findings as follows:
(i) If
the assessment indicated that evacuation of local areas may be advisable,
immediate notification must be made to the Indiana Department of Environmental
Management, Office of Land Quality, Emergency Response Section: (888) 233-7745
for in-state calls (toll free), or (317) 233-7745 for out-of-state calls. The
emergency coordinator must be available to help appropriate officials decide
whether local areas should be evacuated.
(ii) The emergency coordinator must
immediately notify either the government official designated as the on-scene
coordinator for the geographical area in the applicable regional contingency
plan under 40 CFR 112 or the National Response Center using their twenty-four
(24) hour toll free number, (800) 424-8802. The report must include the
following:
(AA) Name and telephone number of
reporter.
(BB) Name and address of
facility.
(CC) Time and type of
incident, such as release, fire, or explosion.
(DD) Name and quantity of material or
materials involved, to the extent known.
(EE) The extent of injuries, if
any.
(FF) The possible hazards to
human health or the environment outside the facility.
(E) During an emergency, the
emergency coordinator must take all reasonable measures necessary to ensure
that fires, explosions, and releases do not occur, recur, or spread to other
used oil or hazardous waste at the facility. These measures must include, where
applicable, the following:
(i) Stopping
processes and operation.
(ii)
Collecting and containing released used oil.
(iii) Removing or isolating
containers.
(F) If the
facility stops operation in response to a fire, explosion, or release, the
emergency coordinator must monitor for leaks, pressure build up, gas
generation, or ruptures in valves, pipes, or other equipment, wherever this is
appropriate.
(G) Immediately after
an emergency, the emergency coordinator must provide for recycling, storing, or
disposing of recovered used oil, contaminated soil or surface water, or any
other material that results from a release, fire, or explosion at the
facility.
(H) The emergency
coordinator must ensure that, in the affected area or areas of the facility:
(i) no waste or used oil that may be
incompatible with the released material is recycled, treated, stored, or
disposed of until clean-up procedures are completed;
(ii) all emergency equipment listed in the
contingency plan is cleaned and fit for its intended use before operations are
resumed; and
(iii) the owner or
operator must notify the commissioner, and appropriate state and local
authorities, that the facility is in compliance with items (i) and (ii) before
operations are resumed in the affected area or areas of the facility.
(I) The owner or
operator must note in the operating record the time, date, and details of any
incident that requires implementing the contingency plan. Within fifteen (15)
days after the incident, the owner or operator must submit a written report on
the incident to the commissioner. The report must include the following:
(i) Name, address, and telephone number of
the owner or operator.
(ii) Name,
address, and telephone number of the facility.
(iii) Date, time, and type of incident, such
as fire or explosion.
(iv) Name and
quantity of material or materials involved.
(v) The extent of injuries, if any.
(vi) An assessment of actual or potential
hazards to human health and the environment, where applicable.
(vii) Estimated quantity and disposition of
recovered material that resulted from the incident.