Sec. 4.
(a)
Regulated asbestos-containing materials, except for Category II nonfriable
asbestos-containing materials regulated under subsection (b), must be managed
in accordance with
326
IAC 14-10, 40 CFR 61, Subpart M*, and the following:
(1) The generator must provide the solid
waste land disposal facility with sufficient notice in advance of the disposal
so that the facility may prepare to accept the regulated asbestos-containing
material.
(2) All regulated
asbestos-containing material must be handled in accordance with the wetting,
packaging, and labeling provisions of
40 CFR
61.145(c) * and
40
CFR 61.150(a) *.
(3) Each load of regulated
asbestos-containing material must be accompanied by a waste shipment record
prepared on one (1) of the following:
(A) A
form provided by the department.
(B) A form produced by the generator that
includes all the information included on the form provided by the
department.
(4) All
regulated asbestos-containing material must be disposed of in accordance with
the following:
(A)
40 CFR
61.154 *.
(B)
326
IAC 14-10.
(C) There must not be direct physical contact
between regulated asbestos-containing material and heavy equipment during
disposal and covering operations.
(D) All regulated asbestos-containing
material must be covered with soil, approved alternative material, or solid
waste before compaction with heavy equipment or within twenty-four (24) hours
of receipt of the waste to prevent airborne release.
(E) Any regulated asbestos-containing
material that is improperly packaged or in which packaging has been damaged
must be placed in the working face of the MSWLF unit or non-MSWLF unit and
covered immediately after placement of the waste.
(F) A certified operator shall be present at
the MSWLF unit or non-MSWLF unit during all handling and disposal of regulated
asbestos-containing material to ensure compliance with this subsection. The
certified operator shall be certified in accordance with 329 IAC 12.
(G) All personnel involved in off-loading or
in covering shall use appropriate personal protective equipment as necessary to
prevent exposure to any airborne release of asbestos fibers during disposal
operations.
(H) The solid waste
land disposal facility must have a written contingency plan to safely control
torn and broken containers. Dedicated equipment and supplies must be maintained
at the facility to properly handle spilled or improperly packaged or wetted
regulated asbestos-containing material. If release of asbestos-containing waste
materials occurs, the solid waste land disposal facility must take immediate
corrective action directed by the certified operator.
(b) Category II nonfriable
asbestos-containing material, as defined in
40
CFR 61.141 *, that has not been made friable
by forces reasonably expected to act on the material before disposal must be
managed in accordance with the following:
(1)
Subsection (a)(1).
(2) Subsection
(a)(3).
(3) Subsection
(a)(4).
(4) Containers or wrapped
materials must be labeled with warning labels that meet the requirements of
29 CFR
1910.1001(j)(4) *, and
include the information in the following figure:
|
DANGER
CONTAINS ASBESTOS FIBERS
AVOID CREATING DUST
CANCER AND LUNG DISEASE HAZARD |
(5)
For asbestos-containing waste material to be transported off the facility site,
containers or wrapped materials must be labelled with the name of the waste
generator and the location at which the waste was generated.
*These documents are incorporated by reference. Copies may be
obtained from the Government Publishing Office, www.gpo.gov, or are available for review at the
Indiana Department of Environmental Management, Office of Legal Counsel,
Indiana Government Center North, 100 North Senate Avenue, Thirteenth Floor,
Indianapolis, Indiana, 46204.
This version of section effective January 1, 2017. See also
preceding version of section, effective until January 1,
2017.
