Sec. 2.
(a) An
application for a restricted waste site Type III or a construction/demolition
site must be accompanied by plot plans using a scale of at least one (1) inch
equals one hundred (100) feet for a site of less than eighty (80) acres, or a
scale of at least one (1) inch equals two hundred (200) feet for a facility of
eighty (80) acres or more. A bar scale must be shown on plans in order to
properly indicate the scale if size changes occur. All plot plans must include
the facility boundaries and indicate each of the required features set forth in
this section within three hundred (300) feet of the facility boundaries. All
facility plan elevations must correlate with United States Geological Survey
(USGS) mean sea level data.
(b) An
application for restricted waste site Type III must be accompanied by the
following plot plans and cross sections:
(1) A
plot plan that indicates the following:
(A)
Locations and elevations of all existing and proposed on-site boring
locations.
(B) Rock
outcroppings.
(C) Surface water
run-off direction.
(D)
Fences.
(E) Utility easements and
rights-of-way.
(F) Present land
surface contours at intervals of no more than five (5) feet.
(G) Proposed location of scales required by
329 IAC
10-14-2.
(2) A plot plan that indicates the fill
boundaries and proposed final contours of the site at intervals of no more than
two (2) feet.
(c) An
application for a construction/demolition site must be accompanied by the
following plot plans and cross sections:
(1) A
plot plan that indicates the following:
(A)
Locations and elevations of all existing and proposed on-site boring
locations.
(B) Rock
outcroppings.
(C) Surface water
run-off direction.
(D)
Fences.
(E) Utility easements and
rights-of-way.
(F) Present land
surface contours at intervals of no more than five (5) feet.
(G) Proposed location of scales required by
329 IAC
10-14-2.
(2) A plot plan that indicates the fill
boundaries and proposed final contours of the site at intervals of no more than
two (2) feet.
(3) A plot plan, with
surface contours at intervals of no more than five (5) feet, which indicates
initial facility development. Compliance with this plan is a preoperational
requirement under
329 IAC
10-35-2. Benchmarks as required by
329 IAC
10-35-2 must be shown with a description and elevation
provided.
(4) A plot plan, with
surface contours at intervals of no more than five (5) feet, which indicates
the following:
(A) Land surface water
diversion structures.
(B)
Berms.
(C) Vegetation or fences for
visual screening.
(D) Sedimentation
control structures and erosion control structures.
(E) Protective barriers.
(F) Leachate collection and methane control
systems if proposed.
(G) Existing
and proposed structures.
(H) The
precise location of the solid waste boundary.
(I) Methods of operation.
(J) Direction and the order operation and
development will proceed.
(K) Depth
of excavation.
(L) Length and width
of trenches if proposed.
(M) Depth
of lifts and size of working face.
(N) Areas of the site to be used only for
acquisition of cover soil.
