Indiana Administrative Code
Title 326 - AIR POLLUTION CONTROL DIVISION
Article 8 - VOLATILE ORGANIC COMPOUND RULES
Rule 14 - Architectural and Industrial Maintenance (AIM) Coatings
Section 14-6 - Compliance provisions and test methods

(a) For the purpose of determining compliance with the VOC content limits in section 3(b) of this rule, the VOC content of a coating shall be determined using the procedures described in subdivision (1) or (2), as appropriate. The VOC content of a tint base shall be determined without colorant that is added after the tint base is manufactured. VOC content shall be determined as follows:

(b) To determine the physical properties of a coating in order to perform the calculations in subsection (a), the reference method for VOC content is Method 24 of 40 CFR Part 60, Appendix A*, except as provided in subsections (c) and (d). An alternative method to determine the VOC content of coatings is SCAQMD Method 304-91* "Determination of Volatile Organic Compounds in Various Materials", February 1996. The exempt compounds content shall be determined by SCAQMD Method 303-91* "Determination of Exempt Compounds", February 1993. To determine the VOC content of a coating, the manufacturer may use Method 24 of 40 CFR Part 60, Appendix A*, or an alternative method, as provided in subsection (c), formulation data, or any other reasonable means for predicting that the coating has been formulated as intended, for example, quality assurance checks, recordkeeping. However, if there are any inconsistencies between the results of a test conducted utilizing Method 24 of 40 CFR Part 60, Appendix A* and any other means for determining VOC content, the results of the test utilizing Method 24 of 40 CFR Part 60, Appendix A* will govern, except when an alternative method is approved as specified in subsection (c). The department may require the manufacturer to conduct an analysis using Method 24 of 40 CFR Part 60, Appendix A*.

(c) The use of alternative test methods demonstrated to provide results that are acceptable for purposes of determining compliance with subsection (b) after review and approval in writing by the department and the U.S. EPA may be used.

(d) Analysis of methacrylate multicomponent coatings used as traffic marking coatings shall be conducted according to a modification of Method 24 of 40 CFR Part 60, Appendix A*. This method has not been approved for methacrylate multicomponent coatings used for purposes other than as traffic marking coatings or for other classes of multicomponent coatings.

*These documents are incorporated by reference. Copies are available for review and copying at the Indiana Department of Environmental Management, Office of Air Quality, Indiana Government Center North, Tenth Floor, 100 North Senate Avenue, Indianapolis, Indiana 46204.